Estate TGP300TQ Dimension Guide

Gas Range

PRODUCT MODEL NUMBERS OVERALL DIMENSIONS

CABINET OPENING DIMENSIONS

TGP300T

Gas supply: Use 3/4" (1.9 cm) rigid pipe gas supply line to the range location. A smaller size pipe on longer runs may result in insufficient gas supply. With L.P. gas, piping or tubing size can be 1/2" (1.3 cm) minimum. If local codes permit, it is recommended that new flexible metal appliance connector, design-certified by CSA, 4-5 feet (122-152.4 cm) long, 1/2" (1.3 cm) or 3/4" (1.9 cm) I.D., be used for connecting the range to the rigid gas supply line. A 1/2" (1.3 cm) male pipe thread is needed for connection to pressure regulator female pipe threads. An individual manual shutoff valve must be located in the same room, but external to the range.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.

Ref. W10121806

10-25-07

Cabinet opening dimensions shown are for 25" (64 cm) countertop depth, 24" (61 cm) base cabinet depth and 36" (91.4 cm) countertop height.

If the cabinet depth is greater than 24" (61 cm), the oven frame must extend beyond cabinet fronts by 1/2" (13 mm) minimum.

29-7/8" (75.9 cm)

width

42"

(106.7 cm)

overall height

24-1/4"

(61.6 cm)

36"

(91.4 cm)

cooktop

height

26-3/4"

(67.9 cm)

depth with

handle

For minimum clearance to top of cooktop, see NOTE.

This shaded area

recommended for

installation

of gas pipe.

This shaded area

recommended for

electrical outlet.

18" (45.7 cm) min. clearance upper side cabinet to countertop

13" (33.0 cm) max. upper cabinet depth

30-¹₈" (76.5 cm) opening width

30" (76.2 cm) min. cabinet opening width

(20.3 cm)

(5.1 cm)

(7.6 cm)

(12.7 cm)

10" (25.4 cm)

2" (5.1 cm) min. countertop space to side wall or other combustible material

24"

(61.0 cm)

NOTE: 24" (61 cm) minimum when bottom of wood or metal cabinet is protected by not less than 1/4" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel,

0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.