Essilor EYE-RULER 2 Installation Manual

INSTALLATION MANUAL
1. DESCRIPTION
Your package includes:
1 Eye-Ruler™ 2 device (1)
1 jig for iPad® (2) (iPad Air
iPad Pro® 9.7, iPad Pro® 10.5, iPad Pro® 12.9, iPad Mini® 4)
1 jig for iPad® 3 and iPad® 4 (3)
1 power supply (4)
2 power adapters (5)
1 magnetic charging cable (6)
2 measurement clips (7)
1 adapter for iPad® 3 (8)
2 magnets (9)
Additional double tape for magnet (10)
Additional double tape for iPad® 3 & 4 adapter (11)
Wipes (12)
®
, iPad Air® 2, iPad® 2017, iPad® 2018,
4
1
7
5
2
8
3
6
11
9
10
12
2. DEVICE PREPARATION
Take the iPad® on which you wish to install Eye-Ruler™ 2 device:
Take the correct jig for your iPad® and position it (1).
Place the jig on the back and align the notch with the front-facing camera (2).
1
2
The iPad must be
perfectly clean to place
the magnet properly.
Peel off the top layer of the sticker on the magnet.
Stick the magnet on it’s designated spot on the jig, then remove the jig (3).
Position the device as it corresponds to the magnet portion (4).
Once the magnet has been
placed, wait for 12 hours.
This is how long it takes the
sticker to dry.
43
3. BLUETOOTH® PAIRING
Once the device is installed on the iPad®, turn on
1
Eye-Ruler™ 2.
A blue light should appear on the side of the device (1).
The Eye-Ruler™ 2 device must be switched on
before launching the app.
Make sure the Bluetooth® is on.
The Bluetooth® connection with the device is
automatic.
Despite this, if the connection fails, select “Settings” (2) on the app and choose
“Reset device pairing” (3).
If the battery icon is full (4), the device is connected with the app.
2
3
4
4. TROOBLESHOOTING
© Essilor International – June 2018. Essilor®, Varilux® X series™ and Eye-Ruler™ 2 are trademarks of Essilor Interna tional. © 2018 Apple Inc. All rights reserved. Apple, the Apple logo, iPad® are trademarks of Apple Inc, registered in the U.S. and other countries. The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth® SIG, Inc. and any use of such marks by Essilor International is under license. Other trademarks and trade names are those of their respective owners.
SCENARIO 1
The device is detected by the app but the LED cannot be turned on.
Please contact your distributor.
SCENARIO 2
The device is not detected by the app.
Check that the device is charged. Green means the device is charged and
yellow means it needs to be recharged soon. If there is no light, there is no battery left. If charging doesn’t work, the power supply needs to be replaced.
Restart the iPad®.
Restart the iPad®’s Bluetooth®.
If it still does not work properly, please contact your distributor.
5. RECOMMENDATIONS
USING YOUR DEVICE
Do not charge the device with a power supply other than the one provided.
Do not try to open the device, the warranty will immediately be voided.
Loading...