Essentials for Living 6135WHTBBRS Assembly Guide
ASSEMBLY INSTRUCTIONS
STELLA 5 DRAWER HIGH CHEST
Parts Check List
Code
QtyComponents
- PLEASE DO NOT DISCARD ANY OF THE PACKAGING UNTIL YOU
HAVE CHECKED ALL THE PARTS AND THE PACKS OF HARDWARE.
- BEFORE YOU BEGIN TO ASSEMBLE YOUR NEW PIECE OF
FURNITURE, PLEASE CHECK TO ENSURE THAT ALL PARTS HAVE
BEEN SUPPLIED.
- FOLLOW INSTRUCTIONS CLOSELY AS DEVIATION FROM THEM
MAY VOID YOUR WARRANTY AND PRESENT A POSSIBLE SAFETY
RISK.
- IT IS RECOMMENDED THAT ASSEMBLY IS DONE ON A SOFT
SURFACE LIKE CARPET TO AVOID ANY DAMAGE.
- PERIODICALLY CHECK AND RE-TIGHTEN ANY FASTENERS. WIPE
DOWN ALL SURFACES WEEKLY WITH A CLEAN CLOTH. DO NOT
CLEAN ANY SURFACES WITH HARSH ABRASIVES OR CHEMICALS.
1.
BODY
x01
Phillips head screwdriver tool needed
(Not included)
2.
FRONT
(HANDLE INSIDE)
BACK
FURNITURE TIPPING RESTRAINT FOR STELLA 5 DRAWER HIGH CHEST
Young children may be injured by tipping furniture and the use
TIPPING KIT CHECK LIST
of a tipping restraint is highly recommended.
CODE COMPONENT QTY
When properly installed, this restraint could provide protection
01 PLASTIC
STRAP 2
against the unexpected tipping of furniture due to small tremors,
bumps or climbing. We recommend mounting this restraint to a
02 SCREW 8
wall stud.
03 NYLON WALL PLUG 4
WARNING: This product is only a deterrent. It is not a
04
PLASTIC
BRACKET 4
substitute for proper adult supervision.
Installation Instruction:
1. Attach one of the plastic brackets (04) securely near the top back edge of the furniture piece by inserting the
screw (02). Refer to picture A.
2. Determine the final position of the furniture piece. Mark location on the wall approximately 2” below the
plastic bracket (04) mounted to the back of the furniture.
3. Drill a starter hole into the wall stud. If wall stud is not available, drill a hole into the wall and insert nylon
wall plug (03). Gently tap plug until the flange of the plug is flush with the wall.
4. Attach a second plastic bracket (04) by inserting and securing the screw (02) to the wall. Refer to picture B.
5. Align the two plastic brackets (04).
6. Thread the plastic strap (01) through both plastic brackets (04) and tighten until snug.
7. Check to make sure that the plastic brackets (04) are firmly installed the plastic strap (01) is secure.
8. Repeat steps 1-7 at other end of furniture piece.
A
BACK SIDE
Starter holes
B
THE WALL
03
04 02
01
040402
BACK SIDE
Loading...