Essential Garden 640-08477458-7 Use And Care Manual

USE AND CARE GUIDE

ESSENTIAL GARDEN PATIO HEATER

Product Code: 640-08477458-7

UPC Code: 6937419204603

Date of Purchase: _____/ _____/ _____

WARNING

For outdoor use only.

DANGER

1. Improper installation, adjustment,

2. Read the installation, operation, and

If you smell gas:

1. Shut off gas to appliance.

2. Extinguish any open flame.

3. If odor continues, keep away from
the appliance and immediately
call your gas supplier or fire
department.

WARNING

1. Do not store or use gasoline or

other flammable vapors and
liquids in the vicinity of this or
any other appliance.

2. An LP-cylinder not connects for

use shall not be stored in the
vicinity of this or any other
appliance.

Save these instructions for future reference.
If you are assembling this unit for someone else,
give this manual to him or her to read and save
for future reference.

If you experience any problems with your heater, DO NOT RETRURN THE PRODUCT TO

THE STORE, please call

1-855-CHANT-US (1-855-242-6887) for

assistances. 8 am to 5 pm Eastern time, Monday to Friday.

WARNING

alteration, service or maintenance can
cause property damage, injury ,or death.

maintenance instructions thoroughly before
installing or servicing this equipment.

DANGER

CARBON MONOXIDE HAZARD

z This appliance can

produce carbon monoxide
which has no door.

z Using it in an enclosed

space can kill you.

z Never use this appliance

in an enclosed space such
as a camper, tent, car or
home.

2

TABLE OF CONTENTS

.

Product Specifications………………………………………………………………..3
Safety Information……………………………………………………………….…...4
Package Contents……………………………………………………………..….…..7
Replacement parts list………………………………………………………………..8

Hardware Contents………………………………………………………….….…....9

Preparation………………………………………………………………….…..........9

Assembly Instructions…………………………………………………………….......9

Operating Instructions…………….………………………………………..…….….15
Care and Maintenance …………………………………………………..……….…16
Troubleshooting………………………………………………………..……………..18
Warranty………………………………………………………………..……….…….18

PRODUCT SPECIFICATIONS

Certification CSA
Height Overall 86.60 inches
Reflector Diameter 31.50 inches
Rated Heat Input 40,000 BTU/HR
Fuel Propane-LP
Gas Supply 20-Lb LP-Gas cylinder
Manifold Pressure 11 inches W.C
Injector Size (diameter) 1.92 mm
Safety Features Thermocouple & Tilt Switch
Gas Supply Pressure Max 150 PSI, Min 5 PSI

3

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate
or install the product. If you have any questions regarding the product, please call
customer service at: 1-855-CHANT-US (1-855-242-6887) from 8:00 am to 5:00 pm
Eastern time, Monday to Friday.

1. CALIFORNIA PROPOSITION 65 WARNING:
(a) Combustion by-products produced when using this product contain chemicals

known to State of California to cause cancer, birth defects and other
reproductive harm.

(b) Handling the brass material on this product exposes you to lead, a chemical

known to the state of California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.

2. The installation must conform with local codes or, in the absence of local codes,

with the

National Fuel Gas Code, ANSI Z223.1 /NFPA 54, Natural Gas and
Propane Installation Code, CSA B149.1, or Propane Storage and Handling
Code, B149.2.

3. Minimum clearance to the combustible materials is 44 inches.

4. Perform a leak test with a soapy solution:

(a) To check gas connections.
(b) After connecting a new cylinder.
(c) Upon re-assembly after disassembly.

Please refer to the leak test procedure indicated in this instruction manual on page

15.
Replace the hose assembly prior to the appliance being put into operation if there
is evidence of excessive abrasion or wear, or if the hose is damaged. The pressure
regulator and hose assembly supplied with the appliance must be used .The
replacement hose assembly/ regulator shall be that specified by the manufacturer.

5. If you don’t feel the heater is on a stable surface, use a ground screw to fix the base

of the heater on the surface where the heater is installed. Fix the base on an incline
no wider than 15 degrees.

6. Place the propane hose with regulator assembly out of pathways where people may

trip over it or in areas where the hose will not be subjected to accidental damage.

7. This heater is equipped with a battery-operated ignition device; please refer to the

assembly instructions on page 14.

8. Materials or items when stored under the heater will be subjected to intense heat

and could be seriously damaged.

9. Clothing or other flammable materials should not be hung on the heater, or

placed on, under or near the heater .

10. Children and adults should be alerted to the hazards of high surface temperatures

and should stay away to avoid burns or clothing ignition.

11. Young children should be carefully supervised when they are in the area of the

heater.

12. Any guard or other protective device removed for servicing the heater must be

replaced prior to operating the heater.

4

SAFETY INFORMATION

13. Installation and repair should be done by qualified service person, the heater

should be inspected before use and at least annually by a qualified service person.

14. More frequent cleaning may be required as necessary. It is imperative that the

control compartment, burners and circulating air passageways of the heater to
kept clean.

15. Keep the appliance area clear and free from combustible materials, gasoline and

other flammable vapors and liquids.

16. Do not obstruct the flow of combustion and ventilation air.

17. Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.

Use this appliance in a well-ventilated space only. Do not use it in a building,
garage, or any other enclosed area.
Use this appliance in outdoor areas described below:
(a) With walls on all sides, but at least one permanent opening at ground level and
no overhead cover.
(b) Within a partial enclosure that includes overhead cover and no more than two

walls. These walls may be parallel, or at right angles to each other.

(c) Within a partial enclosure that includes overhead cover and no more than two

walls. The following shall apply:

(i) One wall that is equivalent to at least 25% of the total wall area is

completely open.

(ii) 30% or more in total of the remaining wall area is open and unrestricted.

18. The LP-gas supply cylinder to be used must be:

(a) Constructed and marked in accordance with the Specifications for LP-gas

cylinders of the U.S. Department of Transportation of Dangerous Goods and
Commission, CAN/CSA-B339, as applicable;

(b) Provided with a listed overfilling prevention device; and
(c) Provided with a cylinder connection device compatible with the connection for

the appliance.

19. Disconnect the cylinder when the appliance is not in use.

20. Storage of an appliance indoors is permissible only if the cylinder is disconnected

and removed from the appliance.

21. Store the cylinder outdoors in a well-ventilated area (not in a building, garage, or

other enclosed area) out of the reach of children.

22. The cylinder used must include a collar to protect the cylinder valve.

23. Do not store a spare LP-gas cylinder under or near this appliance;

24. Never fill the cylinder beyond 80 percent full;

5

SAFETY INFORMATION

25. Place the dust cap tightly on the cylinder valve outlet whenever the cylinder is not in

use. Install only the type of dust cap on the cylinder valve that is provided with the
cylinder valve. Other types of caps or plugs may result in a propane leak.

26. Inspect the visible portion of the hose before each use of the appliance.

27. More frequent cleaning may be required as necessary. It is imperative that the

control compartment, burners and circulating air passageways of the heater be kept
clean.

28. Every part of the heater shall be secure against displacement and shall be

constructed to maintain a fixed relationship between essential parts under normal
and reasonable conditions of handling and usage. Parts not permanently secured
shall be designed so they cannot be incorrectly assembled and cannot be
improperly located or misaligned in removing or replacing during cleaning or other
servicing.

6