E
L
E
C
T
R
O
N
I
C
V
A
P
O
R
I
Z
E
R
S
User Manual
PowerBox
eMOD
eMOD PowerBox
The eMOD PowerBox features a lightweight, ergonomic
design and is powered by a 30W internal battery
Despite it’s small size, the eMOD PowerBox packs
a punch and supports as low as 0.3 sub ohm vaping,
using a single 2200 mAh battery.
SPECIFICATIONS:
• OLED screen with adjustable controls: 7-30W,
2.5-8.5V
• High capacity 2200 mAh battery
• Supports sub ohm vaping, min 0.3 ohm, 0.5 coil
recommended
• Universal 510 connection with spring-loaded center
pin and air channels
• Built-in low voltage/resistance, reverse battery and
short-circuit protection
• Easy five-click On/Off controls
up arrow button
down arrow button the OLED screen
computer
wall adapter
USB cable charge
up arrow button
down arrow button the OLED screen
30.0W
0.00
8.0V
the circle button
1ST TIME CHARGING INSTRUCTIONS:
The PowerBox battery comes partially charged from
the manufacturer, but it is recommended to charge it
to full capacity for first time use.
1. Insert the Micro USB Charger into the receiver located
on the bottom of the PowerBox.
2. Charge battery for at least 4 hours attached to wall
adapter or connection to a computer.
3. The battery level indicator on the OLED screen
will keep flashing during charging.
4. When fully charged, the indicator will stop
flashing and the OLED display will read “Battery Full”.
Safety Features
• Overheat Protection: If you keep pressing the
button for over 10 seconds, the power output will
automatically shut off.
• Atomizer Short-circuit Protection: When atomizer
short-circuit occurs, the OLED screen will reflect
“Atomizer Short”.
• Low power Alert: If the power of battery is lower than
10%, the power symbol on the screen will flash.
• High-safety capacity and stable lithium battery.
Using the eMOD PowerBox
OLED Screen Display Battery condition, resistance,
wattage and voltage.
TURNING ON:
Press the circular power button by clicking 5 consecutive
times within 2 seconds.
SWITCH THE VV/VW MODE:
Press the circular button by clicking three times to switch
the VV/VW mode when the battery is turned on. In VV
mode, you can adjust output voltage between 2.5V-8.5V.
In VW mode, you can adjust output wattage between
5W-30W.
ADJUST THE VOLTAGE/WATTAGE:
Press the up-and-down arrow buttons to increase or
decrease the voltage/wattage. Keep pressing the up/
down arrow button, voltage/wattage will increase or
decrease slowly at first, then they will increase/decrease
at a constant high speed. The number will stop increasing/
decreasing when you release the up/down arrow button.
power resistance
voltage
30.0W
9.9Ω
0.0V
wattage
vapecare
Get useful advice,
inquire about upgrades,
place an order or to
reach customer service.
Visit
EssenceSmoke.com
to become a VapeCare
member today!
Loading...