Page 1
Care@Home
C7000 and EPP Kit
Getting Started
™
PERS
The Best Location for the C7000
Good cellular
reception
Convenient for
resident to access
Where speakerphone can be
heard throughout premises
Page 2
Setting Up the C7000
1
Place thumb in
oval hold and lift
off the cover
1
3
Insert the
backup battery
Insert the SIM
2
4
Connect the power cable
and plug into a power source.
Then close the back cover
Turn the power
5
switch on
Page 3
Using the C7000
Press to cancel an
emergency call
Press to start an
emergency call.
Red light:
● Blinking: alarm in
progress
● On: message
acknowledged
PAIRING button
Shows power status
● On: AC power
connected
● Blinking: using
battery
● Off: no power
Shows communication status
● Green: if on, ready for call.
If blinking, message being
sent
● Red: if on, communication
failure
● Orange: active
conversation
Shows problem status
● On: malfunction in the
C7000 or a peripheral
● Blinking: supervision
lost, or low battery in a
peripheral
Page 4
Setting Up the EPP
Press the PAIRING button
1 2
for 5 seconds.
5
"
Press the button.
3
The panel beeps and the
EMERGENCY button blinks blue.
The EPP in Action
Move the EPP at least 50
cm (20 in.) away from the
C7000.
50 cm (20 in.)
Blue
ESUG05149 Rev 1.0
Panic Button
The EPP blinks red when the panic
button is pressed or a fall is detected
For more information, see: http://www.essence-grp.com/resources/smart-care-download.html
Legal notice: http://www.essence-grp.com/html/concerning_documents.html
www.essence-grp.com • info@essence-grp.com
© 2018 All rights reserved to Essence SmartCare Ltd.
The EPP lights green when
the battery is replaced
Monitoring Station
Loading...