ESP GuardCam User Manual
Combined security camera floodlight system
www.cctvireland.ie
Lo-Call 1890 866 900
e-sales@cctvireland.ie
Table of contents
Contents of package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
GuardCam Motion Light with Video Camera . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Step 1 - Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Step 2 - Insert/remove SD Card . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Step 3 - Installing the GuardCam . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Step 4 - Mounting the GuardCam . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Step 5 - Adjusting the settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Step 6 - Set the Date and Time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Step 7 - Viewing video . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Technical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
General Information and Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Contents of package
GuardCam Motion Light
with Video Camera
User Manual 230W halogen light bulb
1 x Allen key
2 x screws
2 x plastic masonry plugs
SD card reader2G SD card
3
2
www.cctvireland.ie
Lo-Call 1890 866 900
e-sales@cctvireland.ie
GuardCam Motion Light with Video Camera overview
Step 1 - Assembly
Install/replace the halogen lamp (see Fig. 1)
I Make sure to unplug unit or turn off power first.
I Remove floodlight cover by unscrewing floodlight screws using a Phillips head
screw driver.
I If replacing a bulb, take out the existing halogen light bulb.
I Put in new 230 Watt maximum halogen light bulb.
I Replace floodlight cover tightening screws carefully.
Halogen lamp
45º
45º
35º
45º
45º
50º
Waterproof cover
3 mode selection
Camera lens
PIR lens
Low battery indicator
Floodlight Cover
Fig. 1
4
3
www.cctvireland.ie
Lo-Call 1890 866 900
e-sales@cctvireland.ie
Step 2 - Insert/remove SD card (see Fig. 2)
I Unscrew the waterproofed cover using provided Allen key, then insert the SD card
until it automatically locks into place.
I If you need to remove the SD card, please press OFF button and take it out within
30 seconds.
I When LED light turns green, meaning SD card is being read, do not remove SD
card or data may be lost.
I To remove SD card, push in SD card to eject. Once to unlock then pull out.
Installation and replacement of back up batteries
The Function of the back up batteries is to Provide power to complete a part
finished recording if a mains power outage occurs and preserve date/time
settings for a minimum of 120 hours prior to mains power being restored.
Unscrew the screw A and remove back cover. Unscrew screw B and remove
battery cover.
I Put the 3pcs “AAA” 1.5V batteries into the battery compartment and make sure
the polarity (- +) is aligned correctly.
I Replace battery cover and back cover, tightening screws carefully.
G Note: To guard against
damage from battery
leakage it is good practice
to replace batteries on a
yearly basis .
G To maintain battery back
up function please replace
batteries after a total of
120 hours of mains power
failure.
Fig. 2
5
4
www.cctvireland.ie
Lo-Call 1890 866 900
e-sales@cctvireland.ie
Loading...