ESP EZ-LOCK User Manual

USER MANUAL

Contents

EZ-LOCK

and Back Plate

1 x Security Torx Key

4 x Screws and raw plugs

Marking out template

Manual and

Equipment required for controlling one door:-

12 volt DC power supply 2 amp minimum (EV-BPS)
Lock - Magnetic (EVML-250)/Yale type keep 12 volt lock (enter D)
Push to exit button (EVEXIT)
Green break glass emergency release (EVEBG)*

*Note:- for use with Magnetic lock only

Functions of the EZ-LOCK

The EZ-LOCK can control up to two doors by use of pin numbers.
Selectable Pin number length 2,3,4,5 and 6 digits
Programmable door open time 00 to 99 seconds.
Two locations (zone 1, zone 2) are available for programming pin

numbers.

(per zone).

1000 Pins can be programmed for zone 1.
10 Pins can be programmed for zone 2.
Two volt free change over relays one per door.
Door closed function (contact required).
2 push to exit button inputs, one per zone.
Programmable volt free change over relay for door bell functio
P

rogrammable rear tamper.

Internal buzzer for tamper monitoring (auto cut off after 1 min).

2

n.

Sighting Of The EZ-LOCK

plugs

Screws

Site the EZ-LOCK within easy access to the door/doors to be controlled.
Recommended mounting height 1.2m.

Fitting

Using the template mark and drill the fixing and cable entry holes.
Remove security screw from the underside of the keypad and

remove back plate.
Fit and secure the back plate in its final position. (See Fig. 1)
Feed the cable from the keypad though the centre hole of

th

e

back plate.
Clip the top of keypad onto the back plate and secure using the

security fixing screw located on the underside of the keypad.
Make all wiring connections and connect 12 volts DC to the keypad.
The green power LED will now be illuminated on the front of the keypad.

Screw

raw

System wiring

Fig. 1

Torx Screw

3

h

Wiring Diagram and connections

Brown-door status detecting - reed switch
Orange-push to exit button - Zone 1
Yellow-push to exit button - Zone 2

Green - COM

Not Used

Not Used

Door contact - reed switc
Exit button - Zone 1

Exit button - Zone 2
COM

Additional power
supply for lock

4