Esoteric Sound SuperConnector Owners manual

OPERATION OF

SuperConnector

CONNECTION
Connect the SuperConnector per the unit’s label. Use uigh-quality, low capacity cable.

The unit’s basic connection is from the SuperConnector’s “MAIN AMP” jacks to your
main amplifier’s “Tape Recorder Loop.”

Connect any equalizer(s) you have to the “PROCESS” jacks. If you have a mono
equalizer you may want to connect it to PROCESS 1. You can connect multitiple
devices in series. Operating the “STEREO/MONO” switch to MONO would then allow it
to feed both left and right.

Connect any tape recorders you have to the appropriate “RCDR, DAT, CASSETTE”
jacks. Front panel connection is available for connection of a portable recorder via the
“EXT” jacks.

WARNING: If you encounter undo resistance to insertion of a plug into any of the jacks,
try to resolve the problem by slightly bending the plugs ground ring to loosen it. You
want to prevent tearing any of the SuperConnector jacks from the PCB.

OPERATION
Normally, your main amplifier’s “Monitor” switch should be left “In,” and the

SuperConnector’s “SOURCE” and “MONITOR” should be set to “MAIN” and “OUT.”

Listening

Should you wish to utilize any of the addition inputs on the Superconnector, simply set
the SOURCE control to that designation.

Recording

Should you wish to record on any tape recorder connected to the SuperConnector, no
switch operation is necessary. If you want to hear what is being recorded on any of the
tape recorders, do so by setting the MONITOR switch to the appropriate recorder.

Make sure that the particular recorder’s “Tape/Source” switch is set to “Tape.”
To simply play back from a recorder you may use either the SOURCE switch or the

MONITOR switch. It is suggested that you use the MONITOR switch except when you
want to record from on recorder to another(s).

Equalizing

You may alter the sound of any source (be it from main amplifer or any of the other
recorders) by switching in any of the “EQ” devices. You may combine both channels
for old mono records or to record onto cassettes with the “MONO” switch.

WARNING: Never set the SuperConnector’s SOURCE switch to play a recorder whose
“Tape/Source” is set to Source. This could cause a loud electronic squeel that could
damage loudspeakers!

Main Amplifer Listening

You can listen to any main amplifier source while dubbing from decks connected to the
SuperConnector. To do this, simple set the main amplifier’s “Monitor” button to off.

- WARRANTY -

This product has been manufactured to precise standards and rigid quality control. Return
authorization must be obtained before making any return. Unit should be returned in it's
original packing otherwise cost of repair for damage incurred will be charged. We
can advise you as to alternate proper packing should this not be available. Such returns
should be accompanied by a payment of $8.00 shipping and handling. It is fully warranted
against defective materials or workmanship under the normal use for the warranty period
of 1 year from time of purchase to the original owner. Repairs, adjustment for defects or
replacement of parts will be performed free of charge, except:

a)If equipment has been damaged by accident or mishandling.
b)If equipment has been serviced or modified by other than our authorized agents.
c)In case of theft, loss, fire or other calamities by an Act of God.

ESOTERIC SOUND

1608 HEMSTOCK AVE.

WHEATON, IL 60187

VOICE/FAX [phone]

E-Mail: EsotericTT@aol