Esio CB1001 User Manual
Owner’s Manual
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be
followed, including the following:
1. Read all instructions.
2. To protect against risk of electrical shock, do not put Esio System in water or other liquid.
3. This appliance is not intended for use by persons (including children) with reduced physical
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
4. Children should be supervised to ensure safe usage of the Esio System.
5. Unplug from the outlet before cleaning.
6. Do not operate any appliance with a damaged cord or plug, or after the appliance
malfunctions, or is dropped or damaged in any manner. Return appliance to the nearest
Authorized Service Facility for examination, repair, or electrical or mechanical adjustment.
7. Do not use outdoors.
8. Do not let cord hang over edge of table or counter.
9. This product is designed for household use only.
10. Do not install the Esio System in a location exposed to direct sun light.
SAVE THESE INSTRUCTIONS
Electrical Equipment Waste Disposal
By ensuring this product is disposed of correctly, you will help avoid potential negative
consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that
this appliance may not be treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with local environmental regulations for waste
disposal.
For more detailed information about treatment, recovery and recycling of this product, please
contact your local city office, your household waste disposal service or the shop where you
purchased the product.
Esio Hot & Cold Beverage System
Owner’s Manual
This Owner’s Manual provides you with all the information you need to operate your Esio Hot &
Cold Beverage System. To download an even more complete Owner’s Manual, or for product
updates, go to www.esiobev.com. If you still have questions, please call our Customer Service
hotline at 877-898-ESIO (3746).
Esio Hot & Cold Beverage System Specifications:
Total water capacity: 1.85 gallons – 0.4 gallons in hot water tank, 0.5 gallons in cold water tank,
0.95 gallons in top reservoir.
Voltage: 120 Volts AC, 60 hertz, 6.0 Amps
NOTE: If the plug does not fit in the outlet, contact a qualified electrician. Do not modify the
plug in any way.
Beverage Flow Rate: 28-38 ml/sec
Dispense volume: 250-350ml (approximately 8-10 seconds) is recommended.
Beverage temperature recovery: 3 minutes between dispenses for maintaining cold and hot
temperature is recommended.
1
Operating Your Esio Hot & Cold Beverage System
Congratulations and thank you for purchasing your Esio Hot & Cold Beverage System.
You are well on your way to making “YOUR DRINK. YOUR WAY. RIGHT AWAY.”
Step 1 . Set up your Hot and Cold Esio Beverage System
• Unpack the box on the floor
• Place your Esio Beverage System on the countertop where you intend to use it
• Plug your Esio into a grounded plug
• Remove the Water Fill Door from the top of the Esio and add 1.75 gallon of filtered or
purified water to the Reservoir
• Do not fill beyond the Max Fill Line!
1.75 gallons
of water
Solid Green = ready to dispense
Blinking Orange = add water
• Wait two minutes for the water to fill the Hot and the Cold tanks inside the system
• Your Esio system is sanitized at the factory, but we recommend that you dispense and
discard 2 cups of water, each, from the Hot and the Cold side of the Esio as shown
below:
For cold beverage
Press and hold
For hot beverage
Press and hold
2
Press until red light turns on,
1
then 2
2
Loading...