ESI LEDG2 Series, LEDG2-24-SLV, LEDG2-24X3-SLV, LEDG2-36-SLV, LEDG2-24X4-SLV Installation And Use Manual
...
LEDG2
Under Cabinet Light
LEDG2 Rev A 4/17 Multiple Unit Models:
Model LEDG2-24-SLV
Model LEDG2-36-SLV
LEDG2-24X2-SLV
LEDG2-24X3-SLV
LEDG2-24X4-SLV
LEDG2-36X2-SLV
LEDG2-36X3-SLV
INSTALLATION AND USE
LEDG2
PARTS PROVIDED
NOTE:
for each additional light.
PLEASE REVIEW these instructions before beginning the installation. Check that
all parts needed were provided with your order. Contact your supplier if any
operates to your satisfaction.
Light Fixture (1)
20" or 25"
Diffuser (1)
Mounting Clip (2)
Orders of multiple unit models include one 24" jumper cord
Flathead Screw (2)
1
/2
#8-32x
ADDITIONAL TOOLS REQUIRED (if screw mounting)
• Power Drill •
Specifications
• #2 Phillips Screw Driver Bit
• Two lengths: 24", 36" (nominal)
• Color temperature: 3500K
• Power consumption: 24"=11W, 36"=14W
• CRI: 85
• Lumens (with Diffuser): 24"=550, 36"=740
• Lumens (w/o Diffuser): 24"=430, 36"=580
• Lamp life: 50,000 hours
• Continuous dimmer
• 9 ft. power cord
• Occupancy sensor available
Cord Clip (2)
Power Supply (1)
CAUTION:
This install requires a
power drill. This is not
a hand tool install.
1
/8" Phillips Screw Driver Bit
See IMPORTANT SAFETY PRECAUTIONS on page 6.
2
LEDG2
Magnet
STEP 1: Choose a Mounting Method
• The LEDG2 light xture may be installed under the cabinet in one of two
ways:
— Magnet attachment (if the bottom of the cabinet is a steel surface).
— Mounting with screws.
• Review STEPS 2A and 2B to decide which method is most appropriate for
your installation.
STEP 2A: Attach the Light Fixture Using Magnets
• The two mounting clips have very strong magnets built into them.
• Snap one mounting clip onto each end of the xture, with the magnet side
facing up.
Mounting
Clip
Mounting
Clip
Fixture
• Attach the xture to the steel surface.
— Hold the xture on the outside ends and move it slowly into position.
— Take care not to allow your ngers to come between the xture and the
steel surface during installation.
Proceed to STEP 3 on page 5.
3
Loading...