ESI Kata2-MS Series, KATA2-MS-DC-BLK, KATA2-MS-DC-WHT, KATA2-MS-GM-SLV, KATA2-MS-GM-BLK Installation Instructions Manual
...
Kata2-MS
™
installation instructions
dual monitor arm with sliders
Model #KATA2-MS-DC-SLV
Model #KATA2-MS-DC-BLK
Model #KATA2-MS-DC-WHT
Model #KATA2-MS-GM-SLV
Model #KATA2-MS-GM-BLK
Model #KATA2-MS-GM-WHT
Kata2-MS Components and tools
Caution
• Hand tighten screws only. Do not use power tools.
Please review these instructions before beginning the installation. Use the illustrations below to check that all the components needed for your
installation were provided with your order. Do not discard the packaging until the product works to your satisfaction.
Components and tools
for clamp mounting method:
monitor arm assemblies (2) and
clamp base assembly (1)
for both mounting methods:
VESA mount assemblies (2)
for optional
grommet mounting method:
monitor arm assemblies (2), plus...
grommet base cover (1)
grommet base assembly (1)
grommet bar (1)
grommet knob (1)
VESA plate screws (8)
M4x10
VESA locking screws (2)
M4x6 set screws (2)M4x9 set screws (4)
Additional tools required
• Phillips screwdriver
cable clips (2)
M4x15
dual Allen key (1)
2mm and 4mm
clamp base assembly
not included when
optional grommet
mounting is ordered
Page 2
Kata2-MS Assembly
If using optional grommet mounting method:
• Replace step 1 with steps A and B on page 7. Then return to this page and start with step 2 below.
Step# 1: clamp base assembly to worksurface
The thickness of the worksurface must be between 0.5" and 2.1".
• Loosen the clamp suciently to be able to slide it easily onto the worksurface.
• Clamp the assembly to the worksurface in the desired position. Be sure to
tighten the clamp securely.
0.5" – 2.1"
clamp to
worksurface
Step# 2: assemble slider mounts
IMPORTANT: When assembling the slider mounts, the groove on the slider bar must be at the bottom.
• Slide the VESA mount assembly onto the slider bar. Center the assembly on the slider bar.
• Install the M4x9 set screw into the bottom of the VESA mount assembly. Using the 2mm Allen key, tighten the set screw to hold the assembly in place. Be sure the
screw tip fits into the groove on the slider bar.
— After the monitor has been installed, the VESA mount can be moved anywhere along the slider bar by loosening the locking screw no more than one full turn, so that
it stays inside the groove. Be sure to re-tighten the screw to secure the monitor in the desired position.
groove
VESA mount
assembly
slider bar
slider mount set screw
M4x9
2mm
Allen key
Page 3
Loading...