ESET NOD32 ANTIVIRUS - INSTALLATION FOR IBM LOTUS DOMINO, NOD32 ANTIVIRUS Installation Manual
Page 1
ESET NOD32 Antivirus
for IBM Lotus Domino
Installation
w e p r o t e c t d i g i t a l w o r l d s
Page 2
2
ESET NOD32 Antivirus for IBM Lotus Domino
Copyright © ESET, spol. s r. o.
All rights reserved.
No part of this document may be reproduced or transmitted
in any form or by any means electronic or mechanical, for
any purpose without the express written permission of
ESET, spol. s r. o. Information in this document is subject to
change without prior notice.
Certain names of program products and company names
used in this document might be registered trademarks or
trademarks owned by other entities.
ESET, NOD32 and AMON are trademarks of ESET, spol. s r. o.
Microsoft and Windows are registered trademarks of
Microsoft Corporation.
ESET, spol. s r. o.
Svoradova 1, 811 03 Bratislava, Slovak Republic
http://www.eset.sk/en
Technical Support Worldwide:
http://www.eset.com/support
Technical Support for Europe:
http://www.eset.eu/support
REV.20071114-002
Page 3
3
1. Introduction
ESET NOD32 Antivirus for Lotus Domino (AMFE) is a
Lotus Domino server addin, built upon the state-of-theart NOD32 scanning engine. It was designed to protect email communication from virus inltrations propagating
by e-mail, and to lower the e-mail trac by ltering out
undesired e-mail attachments.
ESET NOD32 Antivirus for Lotus Domino utilizes the
same engine as NOD32 2.7, including archive scanning,
advanced heuristics, adware/spyware/riskware detection, etc.
2. Quick Installation
System requirements
• Windows NT 4.0 / 2000 / 2003 server
• NOD32 for Windows (v. 2.51.20 and higher)
• IBM Lotus Domino R5 (v. 5.0.9a and higher)
• IBM Lotus Domino R6
• IBM Lotus Domino R6.5
• IBM Lotus Domino R7
Before you install
Prior to installing ESET NOD32 Antivirus for Lotus Domino, make sure that NOD32 2.7 is already installed on
the Lotus Domino server.
NOD32 2.7 as well as ESET NOD32 Antivirus for Lotus Domino is available for download from Eset’s website http://www.eset.com/download/ using your username and password. For more information about installing
NOD32, read the quick installation guide available at
http://www.eset.com/download/manual.htm.
After NOD32 installation set in the AMON module in
Extension Editor the TMP les not to be checked.
Before you start the installation (uninstallation) of
ESET NOD32 Antivirus for Lotus Domino, quit the Lotus
Domino Server.
Installing ESET NOD32 Antivirus for
Lotus Domino
Installation process:
1. extract the installation package downloaded from
Eset’s website or shipped on a CD
2. navigate to the temporary folder, and run the appro-
priate setup le for your oper. system:
– setup2k.exe – for Windows 2000 / 2003 server
– setupnt.exe – for Windows NT server
3. the installer will search for the current Lotus Domino
notes.ini le and will oer to use the rst le found.
After the le has been found, conrm it by typing
y and pressing ENTER to go ahead with the installa-
tion (img. 1)
4. if the found notes.ini le is not the right le, then type
n and press ENTER to continue
5. type the path to the correct notes.ini and press ENTER
(img. 2)
6. enter the name of a new subdirectory in the Lotus Do-
mino data folder where you want the le to be cre-
ated, and where the ESET NOD32 Antivirus for Lotus
Domino databases will be copied to, and press ENTER
(img. 3)
7. wait for the installation to complete
8. after the installation has completed, press any key to
exit the installation dialog (img. 4)
ESET NOD32 Antivirus for IBM Lotus Domino
(img. 1)
(img. 2)
(img. 3)
Page 4
4
After installation, before Lotus Domino server startup, enter a license key for ESET NOD32 Antivirus for Lotus
Domino product to NOD32 Control Center (NOD32 Control
Center > NOD32 system tools > Settings > License Keys).
The license key is sent to your contact address together
with authorization data by ESET spol. s r. o. After entering
the license key, start Lotus Domino server. At the server
startup, ESET NOD32 Antivirus for Lotus Domino (AMFE)
will be loaded. (img. 6)
After a successful installation, the following les will
be created in the specied folder (i.e. in the Lotus Domino data subfolder):
AMFE help.nsf
AMFE log.nsf
AMFE Mail Review.nsf
AMFE Quarantine.nsf
AMFE Setup.nsf
Uninstalling ESET NOD32 Antivirus for
Lotus Domino
The steps 1 to 5 are identical with those for installation.
6. after the installer has recognized a previous installa-
tion of ESET NOD32 Antivirus for Lotus Domino, it will
oer you to uninstall it from the computer. Type y and
press ENTER (img. 5)
7. wait for the uninstallation to complete
8. after the uninstallation has completed, press any key
to close the installation dialog
3. Setup
ESET NOD32 Antivirus for Lotus
Domino Setup (AMFE Setup)
To congure ESET NOD32 Antivirus for Lotus Domi-
no, open Domino Administrator or your Lotus Notes client (Workspace).
To launch ESET NOD32 Antivirus for Lotus Domino,
click the Enable button in the upper part of the AMFE
Setup (Service status:). After ESET NOD32 Antivirus for
Lotus Domino starts, Lotus Domino Server must be restarted (img. 7).
(img. 4)
(img. 5)
(img. 6)
ESET NOD32 Antivirus for IBM Lotus Domino
Page 5
5
The settings are divided into two groups:
Antiviral Engine Setup:
To display the Engine settings, double click on the setup document. By default, the settings are displayed in
view mode. To edit the settings, click the Edit button.
Settings:
• Status (Enabled/Disabled) – toggles the checking
on/o
• Text to append to bottom of message: - the text
message appended at the end of infected e-mails
Setting up actions that are applied after successful or
unsuccessful cleaning:
• Replace le in message – cleans infected les (cle-
anable)
• Delete le from message – deletes infected les
(regardless of whether they are cleanable or non-cle-
anable)
• Place text into le body – replaces the body of in-
fected les with a text message (the text of the e-mail
will be replaced with the text you enter here)
• Make log entry –enables logging
• Append virus info to message – adds information
about detected threat to email
• Place infected le into quarantine database –
moves infected les to quarantine (img. 8)
Mail Filter Setup:
ESET NOD32 Antivirus for Lotus Domino enables e-
mail ltering based on specied criteria. The ltering can
be accomplished by applying various rules. By adjusting
the lters the proper way, it is possible to lter out spam
eectively.
To create a new lter, click the New Mail Filter button.
To assign dierent priorities to the lters, move them up
and down using the arrow keys. The higher a lter is listed, the higher priority it has. To switch a lter on/o, select a lter and click the Enable / Disable button.
The Filter Settings are displayed after double-clicking
the lter. By default, the settings are displayed in view
mode. To edit them, click the Edit Button.
(img. 7)
(img. 8)
ESET NOD32 Antivirus for IBM Lotus Domino
Page 6
6
Settings
• Status (Enabled/Disabled) – enables/disables the
lter
• Description – name of the lter
Filter settings
• From contains – lters by sender
• To contains – lters by addressee
• Subject contains – lters by subject
• Body contains – lters by text in the e-mail body
• Attachments size – lters by the size of attachment
• Action to take – actions applicable to e-mail messages
– Delete (reject) message – deletes ltered
messages
– Move message to mail review database –
moves messages to the review database
– Log Message to mail review database and
deliver the message – delivers messages to
their addressees and places a copy of the messages to the review database
– Remove attachments and deliver – deletes
attachments and delivers messages subsequently
Strings used for ltering email must commence and
end with an asterisk (e.g. *viagra*). Wildcards can also be
used. A question mark (?) substitutes any one character,
while an asterisk (*) substitutes zero or more arbitrary
characters. Use a semicolon (;) to delimit multiple strings,
if necessary.
Example:
To lter out email from the hotmail.com and yahoo.com
domains, enter **@hotmail.com*;**@yahoo.com* to
the „From contains“ eld.
4. Log, Mail Review and
Quarantine database maintenance
AMFE Log Database
contains a review of all infected e-mails detected. The
database also provides information about the time an incident occurred, the name of the threat as well as the recipient. The information in the database can be sorted by
date or the name of the threats. To enable database logging, select Make log entry, which is located in the Mail
Filter setup.
Quarantine Database
the Quarantine database keeps track of all infected les detected. If needed, the les can be recovered. As in
the previous case, items in quarantine can be arranged
by date or name of inltration. To store infected les in
quarantine, select Place infected le into quarantine database, found in the Mail Filter Setup.
ESET NOD32 Antivirus for IBM Lotus Domino
Page 7
7
Mail Review Database
contains all e-mails that have been ltered. Messages are divided into ‘delivered’ and ‘undelivered’. E-mail
messages delivered to their respective addressees are indicated by this icon (when displaying all messages).
Undelivered e-mails can be sent back to their addressees
– to do so, select messages and click on the Deliver button.
Loading...