Escalade sports T8270 User Manual

OWNER’S MANUAL
Table Tennis Table

Be sure to write your model number and serial number here
for future reference. You can find these numbers printed on
the bottom of the table.

Patent Pending

MODEL # T8270
SERIAL #

READ ASSEMBLY, OPERATING AND SAFETY INSTRUC-

CAUTION:

TIONS CAREFULLY! AT LEAST TWO ADULTS ARE NEEDED
TO PUT THIS TABLE TOGETHER!

Thank you for buying our product. We try hard to ensure that our products are of high quality and free of problems, such as
manufacturing defects or missing parts. However, if you have any problems with your new product, please DO NOT RETURN IT

TO THE STORE!.

DO NOT RETURN THIS PRODUCT TO THE STORE!

Call us at:

TOLL FREE 1-800-426-1421

Please have this Owner’s Manual with you when you call.

Or write us at: CUSTOMER SERVICE DEPT., P.O. Box 889, Evansville, IN 47706

(THIS IS A CONSUMER ONLY NUMBER)

Fax Number: [phone].

Please provide model number and/or part number (not just the key number) of the product and/or part when you call or write. These numbers
can be found on the product, packaging, and/or in this Owner’s Manual.

TOOLS NEEDED:

Phillips Screwdriver, Two 7/16 Wrenches, One 3/8 Wrench (an adjustable wrench may be substituted for the
wrenches), Scissors, Tape Measure

2L-6616-00

1. Lay table top #1 painted side down, on a smooth,
flat surface. Use the shipping container to
protect the painted surface of the table top.

2. Assemble the two “L” tubes and the center tubes
that make up the “U” Support and the “U” Leg.
Align on Table Top as shown in Figure 1. Note:

“U” Leg is larger and wider than the U Support.
The U-leg should be installed on the end of the
table half with the end rail mounting holes.

3. Put plastic caps #13 on the end of U-leg #2.

Figure 1

4. Align the holes in the Large U-clips #3 and the U-clips
#6 with pilot holes in table top assembly and secure
with twenty four screws #20 as shown.

IMPORTANT:

Be sure the slot in the six U-clips #6 all face the
same direction (toward the end of the table with
the U-support) as shown.

Slot in

U-clip #6

Figure 2

IMPORTANT: U-Leg is wider than U-support.
Make sure they are assembled exactly as
shown. If not, there will be a large gap
between table halves and table will not
operate properly!

2

5. Lay out rails #25 and 26, as shown in Figure 3, around

edges of table top.

6. Line up holes in rails with pilot holes in top and secure

using eighteen screws #26. See Figure 4.

Figure 3

7. Attach Corner Cap #22 to top as shown in Figure 4

8. Rotate U-support #7 until you see the screw

hole in the slot of U-clip # 6. Slide U-support
#7 side to side if necessary.

9. Insert screw #19 through slot in U-clip #6 and

into U-support #7. Thread it all the way into U­support #7 until it touches the back of the tube.
There should be about 3/8 inch of screw #19
left sticking out. Repeat for U Leg #2.

Figure 4

Figure 5

3