Escalade sports T8194 User Manual

MODEL NOS.

T8194T8194

T8194

T8194T8194

POWERPLAPOWERPLA

POWERPLA

POWERPLAPOWERPLA

TABLE TENNIS TABLE

OWNER'S MANUAL

1. Read this manual carefully before starting assembly. Read each step completely before beginning

each step.

2. Some smaller parts may be shipped inside larger parts. Check inside all parts and cartons
before assembling or ordering parts.

3. Do not tighten hardware until instructed to do so. If hardware is tightened too soon, mounting holes

may not align and parts may not easily fit together. Leave locknuts slightly loose until you are instructed to
tighten them.

Please Do Not Return This Product To The Store!

Contact Escalade® Sports customer service department at:
Phone: [phone] Toll – Free !
Fax: [phone] Toll – Free !
E-mail: [e-mail]
Mailing Address (correspondence only):
Escalade Sports
PO Box 889
Evansville, IN 47706

YY

Y

YY

Please visit our World Wide Web site at: www.escaladesports.com

ON-LINE TROUBLE SHOOTING TECHNICAL ASSISTANCE

ON-LINE PARTS REQUESTS FREQUENTLY ASKED QUESTIONS

®

ADDITIONAL ESCALADE

Escalade® Sports products may be manufactured and/or licensed under the following patents:
6120397, 5816957, 5769744, 5119741, 4911085, 4717157, D460140, D420563
Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product.

SPORTS PRODUCT INFORMATION

1

2L-6864-00

Figure 1

Figure 2

READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!

1. Attach wood bottom board (#2) to caster rails

(#1) as shown in Figure 1. Turn caster rail as
shown with pivot tubes toward inside, and attach
board (#2) with four carriage bolts (#3) and four
wing nuts (#4). Tighten wing nuts securely.

PIVOT TUBES MUST FACE
INWARD AND POINT
STRAIGHT UP AS
SHOWN!

AT LEAST TWO (2) ADULTS ARE NEEDED TO
COMPLETE THE REST OF THIS ASSEMBLY! WHEN
ASSEMBLING TOPS TO BASE, HANDLE TOP
ASSEMBLIES BY GRASPING ONLY THE TOPS
THEMSELVES. DO NOT GRASP METAL LEGS, U­SUPPORT, LINKAGE, OR HINGES. THESE PARTS
CAN MOVE AND COULD PINCH FINGERS OR
HANDS CAUSING SERIOUS INJURY! ASSEMBLE
AS SHOWN WITH LEGS FULLY CLOSED AND
TOPS IN A VERTICAL POSITION. DO NOT OPEN
LEGS AND TRY TO ASSEMBLE. TABLE TOPS ARE
HEAVY - DO NOT ATTEMPT TO ASSEMBLE
ALONE!

2. Attach table top (#19) to table base that you just

assembled, as shown in Figure 2. With at least one
adult on each side of table top (#19), lift top and
align ends of "U"-support tube with top of pivot tubes
on caster rails (#1). Slide tubes together.

3. With two adults, put other table top onto other pivot

tubes following instructions in step 2.

DO NOT OPEN THE TABLE TO PLAYING POSITION
UNTIL BOTH TOPS ARE INSTALLED! DO NOT LEAVE
TABLE STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS BODILY INJURY
OR PROPERTY DAMAGE.

2