Escalade sports T8183 User Manual

TABLE TENNIS TABLE

MODEL NUMBER

T8183T8183

T8183

T8183T8183

OWNER'S MANUAL

1. Read this manual carefully before starting assembly. Read each step completely before beginning

each step.

2. Some smaller parts may be shipped inside larger parts. Check inside all parts and cartons
before assembling or ordering parts.

3. Do not tighten hardware until instructed to do so. If hardware is tightened too soon, mounting holes

may not align and parts may not easily fit together. Leave locknuts slightly loose until you are instructed to
tighten them.

Please Do Not Return This Product To The Store!

Contact Escalade® Sports customer service department at:
Phone: [phone] Toll – Free !
Fax: [phone] Toll – Free !
E-mail: [e-mail]
Mailing Address (correspondence only):
Escalade Sports
PO Box 889
Evansville, IN 47706

Please visit our World Wide Web site at: www.escaladesports.com

ON-LINE TROUBLE SHOOTING TECHNICAL ASSISTANCE

ON-LINE PARTS REQUESTS FREQUENTLY ASKED QUESTIONS

®

ADDITIONAL ESCALADE

SPORTS PRODUCT INFORMATION

Escalade® Sports products may be manufactured and/or licensed under the following patents:
6120397, 5816957, 5769744, 5119741, 4911085, 4717157, D460140, D420563
Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product.

1

2L-7072-00

Figure 1

Figure 2

READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST THREE (3)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!

1. Position caster rails (#1) on the floor as shown

approximately 30 inches apart.

PIVOT TUBES MUST
FACE INWARD AND
POINT STRAIGHT UP AS
SHOWN!

AT LEAST THREE (3) ADULTS ARE NEEDED TO
COMPLETE THE REST OF THIS ASSEMBLY! WHEN
ASSEMBLING TOPS TO BASE, HANDLE TOP
ASSEMBLIES BY GRASPING ONLY THE TOPS
THEMSELVES. DO NOT GRASP METAL LEGS, H­SUPPORT, LINKAGE, OR HINGES. THESE PARTS
CAN MOVE AND COULD PINCH FINGERS OR HANDS
CAUSING SERIOUS INJURY! ASSEMBLE AS
SHOWN WITH LEGS FULLY CLOSED AND TOPS IN
A VERTICAL POSITION. DO NOT OPEN LEGS AND
TRY TO ASSEMBLE. TABLE TOPS ARE HEAVY - DO
NOT ATTEMPT TO ASSEMBLE ALONE!

2. Have two adults hold the table top (#5) upright,

while a third adult attaches ends of "H"-support
tube with top of pivot tubes on caster rails (#1).
Slide tubes together.

3. Repeat this process for the other caster rail. Then
slide second table top down over remaining two
pivot tubes, making sure the playing surface of
the second top faces the playing surface of the
first.
Attach corner protectors (#32) to rails using tree
plugs (#22). Simply push the plugs through the
protector and into the rail until snug.

DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL
BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE KNOCKED
OVER CAUSING SERIOUS BODILY INJURY OR
PROPERTY DAMAGE.

2