Escalade sports T8100 User Manual

OWNER'S

MANUAL

MODEL NO.

T8100

TABLE TENNIS CONVERSION

TOP FOR POOL T ABLES

Thank you for buying our product. We try hard to insure that our products are of high quality and
free of problems, such as manufacturing defects or missing parts. However, if you have any
problems with your new product, please call us at:

READ

INSTRUCTIONS

CAREFULLY!

You will need a phillips
screwdriver to install.

DO NOT SIT, STAND OR LEAN HEAVILY ON TOPS! THIS UNIT IS DESIGNED TO

WARNING:

1. Lay out rails #2, #3 and #4, as shown in Figure 1, around
edges of table top.

2. Line up holes in rails with pilot holes in top and secure us­ing six screws #6 per rail. See Figure 1.

BE LARGER THAN POOL TABLE TOP. THEREFORE, PORTIONS OF THIS UNIT
WILL NOT BE SUPPORTED AT THE OUTER EDGES. DO NOT USE THIS UNIT ON
POOL TABLES LESS THAN 80 INCHES LONG OR 44 INCHES WIDE!

Or write us at: CUSTOMER SERVICE DEPT., P.O. Box 889, Evansville, IN 47706

Please provide model number, serial number, and/or part number of the product and/or part when
you call or write. These numbers can be found on the product, packaging, and/or in this Owner’s
Manual.

TOLL FREE 1-866-873-3528

(THIS IS A CONSUMER ONLY NUMBER)

FAX: [phone]

NOTE: You may have extra screws #6. This is normal.

Figure 1

3. Lay Corner Caps #8 on table as shown in Figure 2. If Corner
Cap sticks above table top surface of table, flip over so shorter
distance is against edge. Secure to bottom of table with three
screws #9 per Corner Cap.

Figure 2

© 2001 Escalade Sports

2L-6656-00

BOTTOM SIDE OF HALF TOPS #1 SHOWN

TOP SIDE OF HALF TOPS #1 SHOWN

WITH POOL TABLE UNDERNEATH.

Figure 3

INSTALLATION

4. Determine the placement of sponge rubber strips #2 on the bottom of
half tops as follows (Use Figure 3):

! Mark center line ( A) along the length of conversion top. Top is 60

inches wide. Center line (A) is 30 inches in from either side.

! Measure the width of your pool table.
! Divide the width of your pool table in half and mark the bottom of the

conversion top this amount (B). Measure from center line (A) out toward
both sides. These mark the sides of your pool table.

! Measure the length of your pool table.
! Divide length of pool table in half and mark the bottom of the conversion

top this amount (D). Measure from center line (C) (where two half tops
touch) out towards both ends. These mark the ends of your pool table.

! Temporarily tape sponge rubber strips #5 to bottom surface of

conversion top using masking tape (not included). Space them evenly
apart as shown above. (Do not peel backing off strips yet. First check
for correct placement. See next step.)

5. Set one half top on your pool table to check for correct placement of

sponge rubber strips #5.

! If correctly placed, remove top from pool table, peel backing from sponge

rubber strips #5 and apply firmly to back of conversion top. Repeat on
other half top. Place both half tops on pool table.

Replacement Parts List

Item # Part # Description Qty.

1 4A-6536-01 Half Top 2
2 2S-6384-00 Side Rail (48" Long) 4
3 2S-6385-00 End Rail (53" Long) 2
4 2S-6429-00 Stiffener Rail (short) 2
5 BZ-412 Sponge Rubber Strip 12
6 1B-6451-00 #8 X 7/16 Phillips Hex Hd 48
7 2L-6656-00 This Owner's Manual 1
8 3M-6494-00 CORNER CAP 4
9 1B-6449-00 #8 X 5/8 Phillips Hex Hd 12

Figure 4

! If incorrectly placed, mark the correct position on bottom of the conversion

top, remove top from pool table, and apply strips. Repeat on other half.
Set both half tops on pool table.

6. Install net brackets and net (not furnished with this table).
MAINTENANCE

! We do not recommend the use of wax on this top. Wax tends to make the

top excessively shiny.

! To clean, use a warm, damp cloth and WIPE GENTLY! DO NOT WIPE

EXCESSIVELY! DO NOT USE DETERGENTS OR EXCESSIVE
AMOUNTS OF WATER!

! NOTE: Changing weather conditions may cause a slight warpage in the

playing surface of the table. This will not affect playing conditions. Playing
surface will return to its original condition as the weather stabilizes.

STORAGE

This table MUST be stored indoors.

LIMITED WARRANTY

For ninety days from the date of purchase, manufacturer will repair this table tennis
table free of charge, if defective in material or workmanship.
Warranty service is available by simply contacting our Customer Service
Department.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.

2L-6656-00

TABLE TENNIS WARRANTY CENTER, P.O. BOX 889, EVANSVILLE, IN 47706 USA