Escalade sports T8039 User Manual

OWNER'S

MANUAL

MODEL NO.

T8039

883-0226

READ

INSTRUCTIONS

CAREFULLY!

You will need a measuring tape,
a pencil, hammer or mallet, and
masking tape to install.

WARNING:

ASSEMBLY

TABLE TENNIS CONVERSION

TOP FOR POOL TABLES

Thank you for buying our product. We try hard to insure that our products are of high quality and
free of problems, such as manufacturing defects or missing parts. However, if you have any
problems with your new product, please call us at:

TOLL FREE 1-800-426-1421

(THIS IS A CONSUMER ONLY NUMBER)

or in Indiana 1-800-637-4654

FAX: [phone]

Or write us at:

Please provide model number, serial number, and/or part number of the product and/or part when
you call or write. These numbers can be found on the product, packaging, and/or in this Owner’s
Manual.

DO NOT SIT, STAND OR LEAN HEAVILY ON TOPS! THIS UNIT IS DESIGNEDDO NOT SIT, STAND OR LEAN HEAVILY ON TOPS! THIS UNIT IS DESIGNED

DO NOT SIT, STAND OR LEAN HEAVILY ON TOPS! THIS UNIT IS DESIGNED

DO NOT SIT, STAND OR LEAN HEAVILY ON TOPS! THIS UNIT IS DESIGNEDDO NOT SIT, STAND OR LEAN HEAVILY ON TOPS! THIS UNIT IS DESIGNED
TO BE LARGER THAN POOL TABLE TOP. THEREFORE, PORTIONS OF THISTO BE LARGER THAN POOL TABLE TOP. THEREFORE, PORTIONS OF THIS

TO BE LARGER THAN POOL TABLE TOP. THEREFORE, PORTIONS OF THIS

TO BE LARGER THAN POOL TABLE TOP. THEREFORE, PORTIONS OF THISTO BE LARGER THAN POOL TABLE TOP. THEREFORE, PORTIONS OF THIS
UNIT WILL NOT BE SUPPORTED AT THE OUTER EDGES. DO NOT USE THISUNIT WILL NOT BE SUPPORTED AT THE OUTER EDGES. DO NOT USE THIS

UNIT WILL NOT BE SUPPORTED AT THE OUTER EDGES. DO NOT USE THIS

UNIT WILL NOT BE SUPPORTED AT THE OUTER EDGES. DO NOT USE THISUNIT WILL NOT BE SUPPORTED AT THE OUTER EDGES. DO NOT USE THIS
UNIT ON POOL TABLES LESS THAN 80 INCHES LONG OR 44 INCHES WIDE!UNIT ON POOL TABLES LESS THAN 80 INCHES LONG OR 44 INCHES WIDE!

UNIT ON POOL TABLES LESS THAN 80 INCHES LONG OR 44 INCHES WIDE!

UNIT ON POOL TABLES LESS THAN 80 INCHES LONG OR 44 INCHES WIDE!UNIT ON POOL TABLES LESS THAN 80 INCHES LONG OR 44 INCHES WIDE!

CUSTOMER SERVICE DEPT., P.O. Box 889, Evansville, IN 47706

1. Lay two of the table top sections #1 (painted side

down, with pre-drilled pilot holes in the middle of
table) on a smooth, flat surface. Use the shipping
container to protect the painted surface of the table
top sections. NOTE: It is very important that the
surface you are working on is flat. If it isn't, the
table top sections may not line up properly. (See
Figure 1).

3. Attach stiffeners #3 to the table half assembly using screws #4, and

4. Brush any dust or dirt on the top of the table along the seam between

Figure 1

the 1/4" nut driver #7 included. Use the pre-drilled pilot holes and
Figure 2 to locate the stiffeners. Repeat this step for other table half
assembly. NOTE: The screw kit may have extra screws that will not
be used.

each table top board. Carefully apply the striping tape #8 provided
with this table over the seam and trim with scissors. See Figure 3.

Figure 2

Figure 3

2L-6590-00

BOTTOM SIDE OF HALF TOPS #1 SHOWN

TOP SIDE OF HALF TOPS #1 SHOWN

WITH POOL TABLE UNDERNEATH.

Figure 4

INSTALLATION

4.4.

4. Determine the placement of sponge rubber strips #2 on the bottom of

4.4.

half tops as follows (Use Figure 4):
! Mark center line (

inches wide. Center line (

! Measure the width of your pool table.
! Divide the width of your pool table in half and mark the bottom of the

conversion top this amount (
both sides. These mark the sides of your pool table.

! Measure the length of your pool table.
! Divide length of pool table in half and mark the bottom of the conversion

top this amount (
touch) out towards both ends. These mark the ends of your pool table.

! Temporarily tape sponge rubber strips #5 to bottom surface of

conversion top using masking tape (not included). Space them evenly
apart as shown above. (Do not peel backing off strips yet. First check
for correct placement. See next step.)

5.5.

5. Set one half top on your pool table to check for correct placement of

5.5.

sponge rubber strips #5.

Item #Item #

Item #

Item #Item #

1 4A-6330-01 Half Top 2
2 ---- ------ --­3 725-102 Stiffener 10
4 5A-6504-00 Screw Kit (72 pcs. req'd)) 1
5 BZ-412 Sponge Rubber Strip 12
6 2L-6590-00 This Owner's Manual 1
7 7B-6216-00 1/4" Hex nut Driver 1
8 1M-6031-00 1/2" White Striping Tape 1

AA

A) along the length of conversion top. Top is 60

AA

AA

A) is 30 inches in from either side.

AA

BB

B). Measure from center line (

BB

DD

D). Measure from center line (

DD

Replacement Parts ListReplacement Parts List

Replacement Parts List

Replacement Parts ListReplacement Parts List

Part #Part #

Part #

Part #Part #

DescriptionDescription

Description

DescriptionDescription

CC

C) (where two half tops

CC

AA

A) out toward

AA

Qty.Qty.

Qty.

Qty.Qty.

Figure 5

! If correctly placed, remove top from pool table, peel backing from sponge

rubber strips #5 and apply firmly to back of conversion top. Repeat on
other half top. Place both half tops on pool table.

! If incorrectly placed, mark the correct position on bottom of the conversion

top, remove top from pool table, and apply strips. Repeat on other half.
Set both half tops on pool table.

4.4.

4. Install net brackets and net (not furnished with this table).

4.4.
MAINTENANCEMAINTENANCE

MAINTENANCE

MAINTENANCEMAINTENANCE

! We do not recommend the use of wax on this top. Wax tends to make the

top excessively shiny.

! To clean, use a warm, damp cloth and

EXCESSIVELY! DO NOT USE DETERGENTS OR EXCESSIVEEXCESSIVELY! DO NOT USE DETERGENTS OR EXCESSIVE

EXCESSIVELY! DO NOT USE DETERGENTS OR EXCESSIVE

EXCESSIVELY! DO NOT USE DETERGENTS OR EXCESSIVEEXCESSIVELY! DO NOT USE DETERGENTS OR EXCESSIVE
AMOUNTS OF WATER!AMOUNTS OF WATER!

AMOUNTS OF WATER!

AMOUNTS OF WATER!AMOUNTS OF WATER!
NOTE: NOTE:

!

NOTE: Changing weather conditions may cause a slight warpage in the

NOTE: NOTE:

playing surface of the table. This will not affect playing conditions. Playing
surface will return to its original condition as the weather stabilizes.

STORAGESTORAGE

STORAGE

STORAGESTORAGE

This table MUST be stored indoors.

LIMITED WARRANTY

For ninety days from the date of purchase, manufacturer will repair
this table tennis table free of charge, if defective in material or
workmanship.
Warranty service is available by simply contacting our Customer
Service Department.
This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.

WIPE GENTLY!WIPE GENTLY!

WIPE GENTLY!

WIPE GENTLY!WIPE GENTLY!

DO NOT WIPEDO NOT WIPE

DO NOT WIPE

DO NOT WIPEDO NOT WIPE

2L-6590-00

TABLE TENNIS WARRANTY CENTER, P.O. BOX 889, EVANSVILLE, IN 47706 USA