INSTRUCTIONS for
F-15-694-A
July, 2002
REMOTE ARC STARTER
FOR USE WITH
PT-20AM CO-AXIAL SERIES TORCH
Remote Arc Starter, (50-ft leads) .........................P/N 0558002634
Remote Arc Starter, (100-ft. leads) ...................... P/N 0558002635
PT-20AM Torch W/O Rack, 4-ft., RAS ................ P/N 0558002632
PT-20AM Torch W/O Rack, 17-ft., RAS ..............P/N 0558002633
These INSTRUCTIONS are for experienced operators. If you are not fully familiar with the principles of operation and safe
practices for arc welding equipment, we urge you to read out booklet, "Precautions and Safe Practices for Arc Welding,
Cutting and Gouging", Form 52-529. Do NOT permit untrained persons to install, operate, or maintain the equipment. Do
NOT attempt to install or operate this equipment until you have read and fully understand these instructions. If you do
not fully understand these instructions, contact your supplier for further information.
The Remote Arc Starter (RAS) units along with the
above PT-20AM torches may be connected to PCM875, PCM-1125 and ESP-100i consoles. For installation and operating instruction for your cutting package, refer to the appropriate booklet with your con-
Remote Arc Starter
w/ cables
0558002634 - 50'
0558002635 - 100'
Pilot Arc
Connection
Power Cable
Connection
Torch
Connections
PT-20AM
0558002632 (4')
0558002633 (17')
sole. For torch accessories, maintenance and parts
information, refer to PT20AM booklet F-15-114.
You can get extra copies of these booklets through
your supplier. You can also download copies from
www.esab.com.
Control Cable
Pilot Arc Cable
Air Hose
Power Cable
Connections to
Power Source
Work Cable
30741 (25’)
Be sure this information reaches the operator.
You can get extra copies through your supplier.
Loading...