ESAB FS-003-B Foot Operated Remote Current And Contactor Control Instruction manual / Spare parts list (Replacement parts)
Page 1
INSTRUCTIONS for
Fs-003-B Foot opErAtED
rEMotE CurrEnt AnD ContACtor ControL
This remote control is designed for use with below mentioned power sources that employ a single (common) current and
contactor control 12-pin receptacle. It contains a potentiometer which controls the current output when the Panel/Remote
Switch (PRS) (shown below) on the power source is placed in the “Remote” position. This remote control also consists of
a switch when the PRS is placed in the “Remote” position. Both the potentiometer and switch are operated when the FS003-B pedal is depressed. See the schematic diagram in your respective power source instruction literature.
Interconnection of these functions to the main power source is provided by a single mating 30-ft. cable/plug assembly provided.
By depressing the foot pedal, the weld start sequence circuit will energize and the welding current will increase or decrease.
To use the remote control, proceed as follows:
Plug the FS-003-B control cable into current / contactor control receptacle on the power source.1.
Set the Remote / Panel toggle switch to the Remote position.2.
Depress foot pedal as desired to weld.3.
Not for use in 4-stroke mode (trigger latch).4.
For use with: CaddyArc 151i / 201i / A33
CaddyArc 150
CaddyTig 150
CaddyTig 200
Panel/Remote Switch (PRS)
(Is lit when enabled)
wArninG
J
A
H
K
M
G
F
MATING VIEW
MIN
B
C
L
D
E
MAKE surE ALL priMAry powEr to powEr sourCE is
DisConnECtED BEForE instALLAtion oF tHEsE pLuGs.
FS-003-B Foot Control Assembly (30 Ft.)
ESAB P/N 0558008905
0558008907 03 / 2009
Page 2
REPLACEMENT PARTS for
Fs-003-B Foot opErAtED
rEMotE CurrEnt AnD ContACtor ControL
0558008907
FS-003-B Foot Control Assembly (30 Ft.)
ESAB P/N 0558008905
Loading...