INSTRUCTIONS for F-12-549-F
March, 1998
CHECK VALVES
Check Connections
Valve Part Gas
Model No. Service Inlet Outlet
CV-1 639677 Oxygen CGA-024 (7/8—14 RH male)**
CV-2 639710 Fuel Gas CGA-025 (7/8—14 LH male)**
CV-3 639706 Oxygen CGA-022 (9/16—18 RH male)**
CV-4 639711 Fuel Gas 3/4 NPT CGA-023 (9/16—18 LH male)**
CV-5 639717 * (male) 1/2-in NPT (male)
CV-6 639719 Inert Gas CGA-034 (7/8—14RH female)**
CV-7 639720 Inert Gas CGA-032(5/8—18RH female)**
*Any common non-corrosive, non-toxic industrial gas. (See Note 2. )
** CGA-022,-023, etc. were formerly designated “B” size R.H., “B”size L.H.,etc.
(over)
1. Operating pressure must NOT exceed 200 psig.
2. All check valves are cleaned for oxygen service before shipment. If they are used for oxygen service, do NOT use
oil or grease since they ignite easily and burn violently
under pressure in the presence of oxygen.
3. Periodically test the check valve for leakage between the
ball and seat by a reverse flow procedure using Leak Test
Solution suitable for oxygen service, such as P/N 998771(8
oz. container). If there is leakage, replace parts shown below or replace the entire check valve.
*
Be sure this information reaches the operator.
You can get extra copies through your supplier.
INSTRUCTIONS for F-12-549-F
March, 1998
CHECK VALVES
Check Connections
Valve Part Gas
Model No. Service Inlet Outlet
CV-1 639677 Oxygen CGA-024 (7/8—14 RH male)**
CV-2 639710 Fuel Gas CGA-025 (7/8—14 LH male)**
CV-3 639706 Oxygen CGA-022 (9/16—18 RH male)**
CV-4 639711 Fuel Gas 3/4 NPT CGA-023 (9/16—18 LH male)**
CV-5 639717 * (male) 1/2-in NPT (male)
CV-6 639719 Inert Gas CGA-034 (7/8—14RH female)**
CV-7 639720 Inert Gas CGA-032(5/8—18RH female)**
*Any common non-corrosive, non-toxic industrial gas. (See Note 2. )
** CGA-022,-023, etc. were formerly designated “B” size R.H., “B”size L.H.,etc.
(over)
*
*
*Supplied with CV Repair Kit -18360.
F-12-549-F 3/98 4M Printed in U.S.A.
1. Operating pressure must NOT exceed 200 psig.
2. All check valves are cleaned for oxygen service before shipment. If they are used for oxygen service, do NOT use
oil or grease since they ignite easily and burn violently
under pressure in the presence of oxygen.
3. Periodically test the check valve for leakage between the
ball and seat by a reverse flow procedure using Leak Test
Solution suitable for oxygen service, such as P/N 998771(8
oz. container). If there is leakage, replace parts shown below or replace the entire check valve.
*
*
*
Be sure this information reaches the operator.
You can get extra copies through your supplier.
*Supplied with CV Repair Kit -18360.
F-12-549-F 3/98 4M Printed in U.S.A.
Loading...