ESAB Caddy A32, Caddy A34, Caddy A33 Instruction Manual

GB

Valid from program version 1.030460 449 074 GB 08--02--27

A32, A33, A34

Caddyt

Instruction manual

-- 2 --

TOCe

Rights reserved to alter specifications without notice.

1 INTRODUCTION 3...................................................

1.1 Control panel A32 3.........................................................

1.2 Control panel A33 4.........................................................

1.3 Control panel A34 5.........................................................

2 MMA WELDING 6....................................................

2.1 Settings 6..................................................................

2.2 Symbol and Function explanations 6...........................................

2.3 Hidden functions MMA welding 7..............................................

3 TIG WELDING 8.....................................................

3.1 Settings 8..................................................................

3.2 Symbol and Function explanations 8...........................................

4 WELDING DATA MEMORY 9..........................................

5 FAULT CODES 9.....................................................

5.1 List of fault codes 9..........................................................

5.2 Fault code descriptions 10.....................................................

ORDERING NUMBER 11.................................................

-- 3 --

bi20e

1 INTRODUCTION

The manual describes use of A32, A33 and A34 control panels.

For general information about operation see user’s instructions for the power source.

When mains power is supplied the unit runs a self diagnosis of the
LEDs and the display, the program version is displayed and in this
example the program version is 0.18.

1.1 Control panel A32

Display

Knob for setting the current

Choice of welding method MMA or TIG

Setting from panel or connecting remote control unit

Display of VRD function (reduced open--circuit voltage) . This function is not yet

fully supported.

GB

-- 4 --

bi20e

1.2 Control panel A33

Display

Indication of which parameter is shown in the display (current or percent)

Knob for setting data (current or percent)

Buttons for weld data memory settings. See title 4 .

Button for choosing parameters ”Hot start” or arc pressure ”Arc force”

when MMA welding

Choice of welding method MMA or TIG

Setting from panel and connecting remote control unit

Display of VRD function (reduced open--circuit voltage) This function is not yet

fully supported.

GB