Page 1
®
CABLE AND HOSE MANAGEMENT SYSTEM INSTALLATION INSTRUCTIONS
Ericson TuffTraxx is a cable/hose management system intended to reduce the possibility of damage to cables and hose lines that are subject to
pedestrian and vehicular traffic. It is intended for temporary installations only and must be in accordance with all applicable electrical, building and
safety codes. DO NOT use connectors or splices within this system.
CAUTION: MISUSE CAN CAUSE ELECTRICAL SHOCK AND INJURY
• DO NOT use as work surface. NO CUTTING, NO DRILLING, NO HAMMERING.
• Use with momentary loads only, DO NOT place ladders, scaffolds, or any type of structure on the system.
• Avoid concentrated loads.
• Use only on a stable surface. Inclined surfaces, slippery surfaces and broken ground can cause injury.
• This system can be a trip hazard to pedestrian tra ffic if they are unaware of its presence.
• Keep the cable/hose management system clean and bright.
• Load-supporting capacity varies by type of loading conditions and environmental conditions. The load capacity values are listed in the “operating
parameters”. The load capacity decreased in warm environments. Test before use and inspect periodically.
• Keep various services, communications, fluids and power separated. Limit a channel to one service type.
• Polyurethane is attacked by some chemicals. Always test a small amount for chemical compatibility before using and follow maintenance
procedure.
• Vehicular traffic must pass over this system slowly and with caution.
®
MAINTENANCE
• Store in a clean dry area.
• Inspect system for damage and replace it if damaged. Remove any foreign materials, solids and liquids. Keep clean by using
a detergent and water solution.
WARRANTY AND LIABILITY
LIMITED WARRANTY: Ericson guarantees the products it manufactures or sells against defects in workmanship and material for a period of one (1) year from
the date of shipment or date of invoice, whichever is later. The product must be used, maintained and installed according to the instructions and procedures
provided, or this warranty is void. Any alteration or modification of the product will also void this warranty. ERICSON’S OBLIGATION UNDER THIS WARRANTY IS
LIMITED TO THE REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS. No other warranty or remedy shall be provided. This warranty specifically does not guarantee
or cover payment or reimbursement of any damages or consequential damages beyond the above.
Any claim under this warranty must be made in writing within twelve (12) months of the date of shipment or the date of invoice, whichever is later. All products
returned to Ericson under this warranty must be prepaid. If it is determined that the product is defective in material and /or workmanship the repair or
replacement will occur, at Ericson’s option, at no charge and return freight prepaid by Ericson. All other return of product to the owner shall be at the owner’s
expense.
ERICSON AND ITS AUTHORIZED AGENTS, EMPLOYEES AND REPRESENTATIVES SPECIFICALLY AND EXPRESSLY DISCLAIM ANY AND ALL OTHER WARRANTIES, INCLUDING
THE WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND/OR ANY WARRANTY OF MERCHANTABILITY WHICH MIGHT OTHERWISE BE APPLICABLE UNDER ANY
STATE OR FEDERAL LAW.
LIMITED LIABILITY OF ERICSON: Ericson and its authorized agents, distributors and representatives do not guarantee the performance of any Ericson product in
the customer’s use as the manufacturer is unable to assure proper use by the customer. Proper use by the customer is necessary for the effectiveness of the
product, as well as the safety of those using same. The user is solely responsible to determine the suitability of any Ericson product for any intended use. The
user assumes all risk and liability for use of any Ericson product.
User specifically acknowledges receipt of proper instructions regarding the use of the product in the original packaging and disclaims any consequential
damages to person or property, damages for loss of use, lost time, loss of profit, lost income, loss of the Ericson product itself and/or other incidental or
consequential damages other than as warrantied by Ericson’s limited warranty. User accepts the responsibility of removing from service any product that
becomes worn out, unusable, unsuitable for intended use or defective in any way such as to make the product a potential safety hazard. Ericson is unable to
undertake such obligations or responsibilities on behalf of the user as the user is in sole possession and control of the product.
Page 2
4/0
2/0, 4/0
8/3-4/3 8/3-4/3, 4/0-3C
2/0, 4/0
500 MCM 500 MCM
444 MCM 777 MCM
4/0
SOOW Portable 600V 2/3 2/4, 2/5
2/2, 2/3, 4/4, 6/5
2/2, 2/3, 4/4, 6/5
2/0-5C, 3/0-4C, 4/0-3C
2000V
2000V
2000V
600V
600V
600V
18/30, 16/52, 14/24
18/50, 16/60, 14/50
12/50, 10/30
600VSOOW Control
Type W
Stage Lighting
Welding
Utility Control
Type G, G-GC
* - Max O.D. per channel
Type RHH-RHW
DLO Cable
Cable Type*Voltage 4 & 5 channel TuTraxx™3 channel TuTraxx™
®
Assembly:
• Inspect areas for safety hazards.
• Assemble sections by aligning female connectors over male connectors.
• Press with foot to secure female connectors to male connectors.
• Open cover and install cables down into channels.
• Test installation for intended use.
• Periodically inspect installation.
Cable and Hose Management components
CP5-36-XX
®
CP5-36-ECP-XX CP5-45Y-XX-X
Part Number Description A-Length B-Width C-Height D-Channel
CP3-36-ED Extreme duty 3-slot, 36”
CP4-36-ED Extreme duty 4-slot, 36”
CP5-36-ID Industrial duty 5-slot,
CP5-36-ED Extreme duty 5-slot, 36”
Cord Type Voltage CP5-36-ID
SOOW Portable Cord 600V 2/4 2/4 2/5
SOOW Control Cord 600V 12/20, 14/24, 16/44 12/24, 14/24, 16/60 ALL
Type W Single Conductor 2000V 350 MCM 500 MCM >500 MCM
Type W Multi-Conductor
Power
Type SC Single Conductor 600V >4/0 >4/0 >4/0
Welding Single Conductor 600V 500 MCM >500 MCM >500 MCM
Type G Multi-Conductor 2000V G-4/4 G-4/4 G-3/0-4C
straight section
straight section
36” straight section
straight section
2000V 2/2, 4/4, 6/5 2/3, 4/4 3/0-4C, 4/0-3C
Operating Temperature:
-40 °F to +120 °F (-40 °C to +49 °C)
®
36”
91 cm.
36”
91 cm.
36”
91 cm.
36”
91 cm.
(1.25" Max Diameter)
20”
51 cm.
19.5”
50 cm.
1 7. 25”
44 cm.
19.5”
50 cm.
(1.33" Max Diameter)
3.08”
7.8 cm.
2.25”
6 cm.
2.00”
5.1 cm.
2.25”
6 cm.
CP4-36-ED
CP5-36-ED
CHEMICAL RESISTANCE:
Tested for compatibility with common motor oils, gasoline
and diesel fuel. Limited resistance to brake fluids and other
chemicals.
Width
2.22”
5.6 cm.
1.78”
4.5 cm.
1.36”
3.5 cm.
1.40”
3.5 cm.
CP3-36-ED
(2" Max Diameter)
E-Channel
Height
2.25”
6 cm.
1.33”
3.4 cm.
1.27”
3.2 cm.
1.33”
3.4 cm.
Weight
28 lbs.
12.7 kg.
23.5 lbs.
10.7 kg.
20.6 lbs.
9.3 kg.
23.5 lbs.
10.7 kg.
Straight Section Body UV resistant, stabilized polyurethane
Hinges
MaterialMax load per tireMax load per axle
CP5-36-ID 13,500 lbs. @ 70° F (6,1 23 kg. @ 21° C)
CP3-36-ED 25,000 lbs. @ 70° F (11,340 kg. @ 21° C)
CP4-36-ED 25,000 lbs. @ 70° F (11,340 kg. @ 21° C)
CP5-36-ED 25,000 lbs. @ 70° F (11,340 kg. @ 21° C)
CP5-36-ID 27,000 lbs. @ 70° F (12,247 kg. @ 21° C)
CP3-36-ED 50,000 lbs. @ 70° F (22,680 kg. @ 21° C)
CP4-36-ED 50,000 lbs. @ 70° F (22,680 kg. @ 21° C)
CP5-36-ED 50,000 lbs. @ 70° F (22,680 kg. @ 21° C)
Reinforced fiberglass
4323 Hamann Parkway
Willoughby, OH 44094
info@ericson.com
1.800.ERICSON · ericson.com
C8020577 Rev F
Loading...