ERICO TDX100SM User Manual

Side Mounting Bracket

Side Mounting Instructions

PREPARATION

DANGER: Electrical shock or burn hazard.
Installation of TVSS should be made by qualified

personnel. Failure to lockout electrical power
during installation or maintenance can result in fatal
electrocution or severe burns.

These installation instructions apply for the installation of the
TDX range of Surge Protectors onto the side of a Load Center
using the TDX Side Mounting Brackets. These instructions are
to be used in conjunction with the installation instructions for
the TDX product.

It is recommended that this installation use a 90° pulling elbow.
As dimensions of various manufacturers pulling elbows vary,
check fit before installing.

TDX50SM

TDX100SM

NOTE:

Separate Side Mounting Kits are available for either the TDX50
range of products or for the TDX100 & TDX150 range of
products. Please ensure that this kit is the correct model for the
application intended.

Each kit Contains:
a) 2 x Mounting Brackets

b) Instructions

Quick Installation

1. Disconnect and lockout electrical power to the electrical

panel (load center / panelboard / circuit breaker box) where
the TDX is to be installed. Follow all applicable electrical
codes and procedures.

2. Loosen side screws in both TDX end plates as shown in

Figure 1. Screws should be loosened on the side to be fixed
to load center only. Install TDX Side Mounting Brackets and
retighten TDX screws. There is no need to remove the
screws

3. Attach 90° Pulling Elbow (not included in this kit) to the

TDX unit.

4. Ensure panel is isolated and pre-drill holes for conduit

elbow and mounting screws. Align TDX unit and fasten to
Load Center with appropriate fasteners.

5. Complete electrical TVSS connection as per TVSS

instructions.

 2002 ERICO Inc, 34600 Solon Rd, Solon, OH 44139 Page 1 of 1 Doc: HBCR1651, Rev: 2, Date: OCTOBER 28, 2002