ERICO TDSGAWB User Manual

INSTRUCTION SHEET

TDSGAWB Series

Grounding Bus

Flat Washer

Apply a coating of anti-oxide compound to

both sides of the lug(s) prior to installation.

Apply 20 ft-lbs[27N-m] (max)

Belleville Washer

Hex Nut

Apply anti-oxide compound

Note: In the absence of a torque wrench, snug nuts

and tighten 1/4 turn. (Figure 6)

Hold

The grounding bus must be electrically connected to the grounding system. When using a CADWELD®

exothermic connection, remove any coatings, platings or galvanizing prior to making the connection. After

the connection is made, cover any exposed steel with cold galvanized coating (T372A, T358 or equivalent).

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

1.

www.erico.com

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

2.
All instructions must be

3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

4.
damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT

www.erico.com

and from your ERICO customer service representative.

completely

followed to ensure proper and safe installation and performance.

IP8251_B

1 OF 1

© 2012, 2013 ERICO International Corporation.