ERICO IP6574 User Manual

INSTRUCTION SHEET

Cable to Ground Rod,
Horizontal Tee with
Cable and Tap

Tap Cable

ERICO Mold Sealer
(ERICO Part Number
T403)

Run Cable

Ground Rod

Prior to making a connection, read and follow the full instruction sheet IPRNS, the
full instruction sheet IPP, the full instruction sheet shipped with CADWELD (IPX),

®

and special instructions below.

Do not cut run cable. 1.

Place mold on rod and cables with run cable on top of rod and end of tap 2.
cable under center of tap hole (As shown above).

Support mold with locking pliers or clamp on rod.3.

WARNING:

1. ERICO products shall be installed and used onl y as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.

2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manne r that exceeds specified load ratings.

3. All instructions must be completely followed to ensure proper and safe installation and performance.

4. Improper installation, misuse, misapplication or other failure to completely foll ow ERICO's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT:

www.erico.com

IP6574_E

1 OF 1

© 1995, 2004, 2012, 2013
ERICO International Corporation