ERICO IP6556 User Manual

INSTRUCTION SHEET

Horizontal Through
Parallel Side by Side

Type 1 Type 2 Type 3 Type 4

Prior to making a connection, read and follow the full instruction sheet IPRNS, the full
Instruction sheet IPP, the full instruction sheet shipped with CADWELD (IPX),

®

and special instructions below.

Position uncut conductors into mold slots - side by side 1.

2.

For Types 2, 3 and all lightning cable pack opening around conductors at entry
point into mold which may leak molten material with ERICO packing material

WARNING:

1. ERICO products shall be installed and used onl y as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.

2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manne r that exceeds specified load ratings.

3. All instructions must be completely followed to ensure proper and safe installation and performance.

4. Improper installation, misuse, misapplication or other failure to completely foll ow ERICO's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT:

www.erico.com

IP6556_C

1 OF 1 © 1995, 2012, 2013

ERICO International Corporation