ERICO CADWELD Ground Plate and Cable to Steel Surface User Manual

INSTRUCTION SHEET

ERICO® CADWELD®

Ground Plate and Cable to Steel Surface

Mold

L160 Handle Clamp

Steel Plate

Ground Plate

.06

2

Gap

Cable

Prior to making a connection, read and follow the full instruction sheet:
IPP = Grounding applications
IPP & IPRNS = Rail properties
shipped with ERICO CADWELD mold and special instructions below.

1. Place mold firmly against flat steel surface.

2. Insert ground plate until flange area comes in contact with back of mold.
Back off the ground plate 0.06inch [2 mm].

3. Position cable in mold as shown, in contact with ground plate stud.

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

1.

www.erico.com

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

2.
All instructions must be

3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

4.
damage, serious bodily injury and death.

and from your ERICO customer service representative.

completely

followed to ensure proper and safe installation and performance.

SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT

www.erico.com

IP8288_A

1 OF 1

© 2014 ERICO International Corporation.