ERICO CADDY SPEED LINK Riveted Accessories User Manual
INSTRUCTION SHEET
R
CADDY SPEED LINK Riveted Accessories
CADDY
R
Locking Device
1.5mm
CADDY
R
CADDY
R
CADDY
R
Locking Device
2mm
Description
1.5mm
2mm
wire/rope
wire/rope
Load
KG
20 44
45
LB
100
0.5 x "D" = 60
<
60°
"D"
KG/LB
0.85 x "D" = 60
KG/LB
<60°
"D"
KG/LB
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
6.
other purpose.
This product is for use in static load applications only.
7.
Do not exceed the static load limits stated in these instructions.
8.
Although the CADDY SPEED LINK locking device can be used with steel cable meeting the cable specifictions set forth below, the use of other manufacturer's
9.
products in conjunction with CADDY SPEED LINK voids all ERICO warranties and UL listings.
Use CADDY SPEED LINK only where steel cable does not come in contact with sharp, unguarded edges.
10.
CADDY SPEED LINK assembly shall be used only in a non-corrosive indoor environment.
11.
1.5mm stainless steel CADDY SPEED LINK assembly can be used in environments that are compatible with 304 stainless steel. The customer is responsible for
12.
determining the environmental suitability.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
and from your ERICO customer service representative.
completely
followed to ensure proper and safe installation and performance.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com
CFS465_D
1 OF 4
© 2012, 2013 ERICO International Corporation
INSTRUCTION SHEET
KG/LB
*Nut and washer not included.
KG/LB
TECHNICAL SUPPORT:
www.erico.com
CFS465_D
2 OF 4
© 2012, 2013 ERICO International Corporation
Loading...