ERICO CADDY SPEED LINK-Accessory Cables User Manual

INSTRUCTION SHEET
CADDY SPEED LINK
®
Accessory Cables
Y-Toggle
SLDxxYxxxx
Y-Hook
SLDxxYHxxxx
N/LB
Quad-Toggle
SLDxxQTxxxx
Description
1.5mm
2mm
3mm
wire rope
wire rope
wire rope
LOAD
N/LB
N
LB
196
44
445 100
890 200
Quad-Toggle
Y-TOGGLE
Y-TOGGLE WITH HOOKS
Control
(Not Included)
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2. All instructions must be
3. Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4. damage, serious bodily injury and death. Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
5. All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
6. other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for: a. Conformance to all governing codes. b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer. c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS: All governing codes and regulations and those required by the job site must be observed. Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
and from your ERICO customer service representative.
completely
followed to ensure proper and safe installation and performance.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com
CFS515_A
1 OF 1
© 2014 ERICO International Corporation.
Loading...