ERICO 561175 Instruction Sheet
INSTRUCTION SHEET
INSTRUCTION SHEET
SB2C2C1000AL
SB2C2C1000AL
561175
561175
Top
43.3mm
1.70in
Bottom
5.1mm
.20in
222.3mm
8.75in
210.9mm
8.31in
IEC 60947-7-1
1200 A
1000 VAC / 1500 VDC
Uimp = 12kV; Ipk = 75 kA
Icw kA rms 1s = 72
109.5mm
4.31in
UL 1953
1000 V AC/DC
SCCR up to 100kA*
For voltage
measurement only.
6-32 UNC-2B
9 in-lbs [1.0 N-m]
4 mm² /12 AWG max
20.8mm
.82in
840 A
AL or CU Conductor
IP20
95% Fill Ratio
Halogen Free
UL 94 V-0
No. Terminals
2 (TOP)
2 (BOTTOM)
No. Terminals
2 (TOP)
2 (BOTTOM)
NOTE:
*Refer to UL file E497276.
1.
For multiple phase assemblies, join blocks together before installing onto DIN profile.
2.
When mounted on DIN profile, end stops should be used on both ends of gangable blocks.
3.
For IEC, the cable must be secured within 15 cm of the terminal.
4.
WARNING:
nVent products shall be installed and used only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at
1.
www.nVent.com
nVent products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
3.
Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and/or death, and void your warranty.
and from your nVent customer service representative.
completely
followed to ensure proper and safe installation and performance.
Conductor
Conductor
IEC 60947-7-1
Size
35 mm² to
300 mm²
UL 1953
Size
2/0 AWG to
600 kcmil
DIA
23.5 mm
DIA
0.92 in
Torque
42.4 N-m
Torque
375 in-lbs
Strip Length
35 mm
70 mm
Strip Length
1.38 in
2.75 in
Hex
10 mm
Hex
3/8 in
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
nVent, CADDY, ERICO CADWELD, ERICO CRITEC, ERICO, ERIFLEX, and LENTON are owned by nVent or its global affiliates. All other
trademarks are the property of their respective owners. nVent reserves the right to change specifications without prior notice.
TECHNICAL SUPPORT
www.nVent.com
IP8392_A
1 OF 1
© 2018 nVent All Rights Reserved
Loading...