Ergotron APB-1112G, APB-1112H, LifeKinnex, APB-1112, APB-1112B User Manual

1 of 15

888-83-080-G-00 rev. B • 01/19

www.ergotron.com |

USA: 1-800-888-8458

|

Europe: [phone]

|

China: 400-120-3051

|

Japan: [e-mail]

English, Español, Français, Deutsch, Nederlands, Italiano, Svenska, 日本語, 汉语

Power Module

User's Guide

English

For the latest User Installation Guide please visit: www.ergotron.com

The LiFeKinnex Power Module is intended to provide uninterrupted AC power to support AC powered computer equipment.
The Power Module is not intended to power medical products or devices.
Please review this manual before installing your equipment to learn how to use this product safely.
This product is a certifi ed medical power module according to IEC/EN 60601-1, as class I equipment. This power module is intended for use with IEC
60601-1 certifi ed equipment in the patient Environment and IEC 60601-1 and IEC 60950-1 certifi ed equipment outside of patient environment.
AC input: 100-240V~ 50/60-Hz. Max amps: 4.8 - 2.1A.
Manufactured for Ergotron by Green Cubes Technology www.greencubestech.com
Patents Ergotron.com/patents
Battery Sold Separately.

2 of 15

888-83-080-G-00 rev. B • 01/19

CAUTION: To avoid the potential to pinch cables it is important to
follow the cable routing instructions in this manual. Failure to follow
these instructions may result in equipment damage or personal injury.

Equipment Electrical Safety

WARNING: Failure to observe the following Electrical Safety notices can result in fi re or death by electric shock.

Electrical cables can be hazardous. Misuse can result in fi re or death by electrical shock.

• Inspect power cables thoroughly before each use.

• Do not use cables that are damaged.

• Insert the plug completely into the outlet.

• Grasp the plug to remove from the outlet.

• Do not unplug by pulling on the cable.

• Do not use excessive force to make connections.

• Do not plug the cable into an extension cable.

• Do not remove, bend or modify any metal prongs or pins of cable.

• Do not drive, drag or place objects over the cable.

• Do not walk on the cable.

• Avoid overheating.

• Do not run cable through doorways, holes in ceilings, walls or fl oors.

Keep away from water.

• Do not use it when wet.

• Do not place in close proximity to fl ammable liquids or gases.

WARNING: Use of this equipment adjacent to or stacked with other equipment should be avoided because it could result in improper operation. If such use is

necessary, this equipment and the other equipment should be observed to verify that they are operating normally.

WARNING: Use of accessories, transducers and cables other than those specifi ed or provided by the manufacturer of this equipment could result in increased

electromagnetic emissions or decreased electromagnetic immunity of this equipment and result in improper operation.

CAUTION: The power disconnect for this equipment is the AC power cable.
Do not use this unit outdoors.
Never unplug this product from the outlet when your hands are wet.
Any modifi cations made to this device that are not approved, may void the authority granted to the user by the FCC to operate this equipment.
Ensure the product is connected to an outlet having the same confi guration as the plug. No adapter should be used with this product.

Ergotron does not accept any liability for damage if the unit is misused, incorrectly operated or inadequately repaired. Under these circumstances the warranty will be
void.

DANGER! Electrical cables can be hazardous.
Misuse can result in fi re or death by electrical shock.

These symbols alert users of a safety
condition that demands attention. All users
should be able to recognize and understand
the signifi cance of the following Safety
Hazards if encountered on the product or
within the documentation. Children who
are not able to recognize and respond
appropriately to Safety Alerts should not use
this product without adult supervision!

Hazard Symbols Review

Safety

Symbol Signal Word Level of Hazard

INSTRUCTIONS

Refer to instruction manual/booklet.
Follow instructions for use.

CAUTION

A CAUTION indicates either potential damage to
hardware or loss of data and tells you how to avoid the
problem.

WARNING

A WARNING indicates either potential for property
damage, personal injury, or death.

DANGER

A DANGER indicates a hazardous situation that, if not
avoided, will result in death or serious injury.

3 of 15

888-83-080-G-00 rev. B • 01/19

Do not attempt to connect the power modules in serial or parallel with any other power modules. This system was not designed to serve this purpose.
This power module shall be installed by qualifi ed personnel only. The system shall be always installed in the vertical direction as shown in the picture on cover page.

WARNING: DO NOT charge battery with any other charger.

WARNING: Battery contains magnets. Magnets may be harmful to persons with implanted medical devices. Keep battery at least 6" (152 mm) away from any

implanted medical devices.

WARNING: Keep battery and Power Module cool or at room temperature
Operating Temperature: 10°C to 40°C (50°F to 113°F)
Storage Temperature: -20°C to 45°C (-4°F to 113°F)

WARNING: Never attempt to open or service the battery.

WARNING: Never attempt to short circuit the battery or the Power Module intentionally.

WARNING: DO NOT drop, puncture or crush battery or expose to water.

WARNING: DO NOT dispose battery in fi re in any circumstances. Keep battery pack away from any hot source.

WARNING: DO NOT use battery if physical damage is evident.

WARNING: To avoid risk of electric shock, do not expose electrical component to water, cleaning solution or other potentially corrosive liquids or substances.

WARNING: To avoid risk of electric shock, this equipment must be connected to AC mains with protective earth.

WARNING: In rare case, if the power module and battery protection features fail, the battery may become overcharged and in some instances, it may become
extremely hot, possibly melting the plastics and releasing smoke.
If a battery begins to smoke or melts:

Unplug the cart, or if possible disconnect the battery from Power Module immediately.
Move the cart to a well-ventilated area.
Use a Carbon Dioxide, Dry Chemical, or appropriate foam fi re extinguisher to spray the hot battery. If a fi re extinguisher is not available, use copious amounts of

water, or cover the battery with sand. Exposure to vapor released from the battery is irritating to the eyes, skin, mucous membranes, and respiratory tract.
This may cause nausea, dizziness, and headache.
In case of direct contact to the battery's electrolyte:
Immediately fl ush eyes with water for at least 15 minutes.
Thoroughly rinse hands and other aff ected areas with water.
Promptly remove and wash any contaminated clothing.
In all cases, seek immediate medical attention!

Placement:
Do not expose the Power Module to direct sunlight or other heat source.
Ensure the operating environment is well ventilated to allow adequate dissipation of heat.
Ensure the Power Module surrounding area is clean and free from moisture.
Do not put heavy objects on the Power Module.
The socket outlet should be easily accessible and should be installed near the equipment.

AC Inlet power cords:
AC mains plug shall have the protective earth pin. By connecting the plug to the Power Module,
it shall have not more than 200mΩ to any part of the system metal case.
The connector shall be an IEC 60320 compliant C13 plug.
The power cords shall be IEC 60227 or HO5VV compliances.
AC Outlet power cords:
The connector shall be an IEC 60320 compliant C14 inlet.
The power cords shall be IEC 60227 or HO5VV compliant.

Safety

4 of 15

888-83-080-G-00 rev. B • 01/19

Features & Specifi cations

EMC levels are evaluated according to IEC60601-1-2/EN60601-1-2.
This power module was not designed to be water proof, therefore,
its classifi ed as IPX0 and also not evaluated as AP/APG equipment.

Certifi cation:
UL 60601-1 Safety of Medical Electrical Equipment
CAN/CSA C22.2 No. 601.1
IEC 60601-1
ICES-003 Issue 5, Class A
FCC Part 15 Class A
RoHS and REACH compliant material used.

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference
that may cause undesired operation.
CAN ICES3(A)/NMB-3(A).
Changes or modifi cations not expressly approved by the Ergotron could void
the user's authority to operate the equipment.
Intended for institutional use.
Note: The emissions characteristics of this equipment make it suitable for use
in industrial areas and hospitals (CISPR 11 class A). If it is used in residential
environment (For which CISPR 11 class B is normally required) this equipment
might not off er adequate protection to radio-frequency communication services.
Mitigation measures, such as relocating or re-orienting the equipment may be
necessary.

Regulatory Model Number APB-1112G APB-1112H APB-1112B APB-1112 APB-1112C APB-1112D APB-1112F

Part Number 916-501-00 916-338-00 916-499-00 916-334-00 916-337-00 916-336-00 916-335-00

Input Voltage Range 100~ 240Vac

Frequency 50 / 60 Hz

Power Factor PF>0.94/230Vac PF>0,98/115Vac

Output Voltage Range (+/-3%) 100Vac 100Vac 120Vac 120Vac 127Vac 220Vac 230Vac

Frequency (+/-1 Hz) 50 60 50 60 60 60 50

Wave form Pure Sine Wave

Output Power (Continuous) 150VA

Output Power (Maximum) 180VA average up to 5 minutes

Output Power (Peak) 200VA average up to 1 second

Swappable

Battery

Lithium Iron

Phosphate

245Wh

916-333-00

Nominal Voltage 12.8V

Nominal Capacity 19.2Ah/245Wh

Charging Voltage 14.4V

Maximum Charging Current 15A

Maximum Discharge Current 21A

Approximate Weight 6.2lbs

Communication SMBUS

Operating Ambient Temperature 10° to 40°C

Transportation Temperature/Humidity -20° to +70°C/ 5% to 95%

Storage Temperature/Humidity -20° to +45°C/ 5% to 95%

Ambient Relative Humidity 20 to 90% Non-Condensing

Operating Altitude 4000 meters

5 of 15

888-83-080-G-00 rev. B • 01/19

AB CD

1

2

3

4

mm

1x

1x

1x

4x

1x

1x

1x

1x

1x

1x

2x

1x

M3 x 8mm

5x

M5 x 10mm

4x

M4 x 8mm

1x

Battery Sold Separately.

Lithium Iron Phosphate 245Wh, 916-333-00

Tools Needed

Components

Power Module

Display

Cable Wrap

Cable Tie

Display Base

Hex Wrench

Bottom Cover

Power Strip

Screw

Back Cover

Coiled Cord

Screw

Mounting Bracket

T-Slot Bracket

Screw