ERGOMART SAA7000 Installation Instructions Manual
SAA7000 MONITOR ARM
Installation Instructions
www.ergomart.com | 888 420 3200
21 3
A.
B.
C.
C.
C.
Insert arm pin into completely attached
and assembled mount.
C.
Attach VESA plate to tilter head.
Attach tilter head/VESA plate to
Monitor.
* Some monitors may require a spacer
hardware kit. See page 3 for details.
4 5 6
D.
D.
D.
D.
E.
F.
Adjust vertical tilt resistance on tilter
Slide tilter pin into end of arm.
head.
7 8
H.
Increase resistance to rotation at
articulation points by tightening small
set screws.
DO NOT OVERTIGHTEN.
G.
G.
Put arm in horizontal position and
rotate wrench CLOCKWISE to WEAKEN
arm until monitor stays wherever it is
placed. See page 2 for more detailed
instructions.
Please call Ergomart at
888 420 3200
with your questions
I.
www.ergomart.com
Ergonomic solutions for office and light industrial work environments
©2016 Ergomart. All rights reserved.
PAGE 1 OF 3
SAA7000 MONITOR ARM
Installation Instructions
www.ergomart.com | 888 420 3200
How do I counterbalance my arm?
1
7/32" Allen Wrench
2
IMPORTANT!
• Monitor must be on arm
• Arm must be in mount
Press the arm down to
Press the arm down to
approximately parallel with the
approximately parallel with
desk prior to turning the strength
the desk prior to turning the
adjustment screw.
strength adjustment screw.
_
If the arm drifts upward,
If the arm drifts upward, turn
turn the adjustment screw clockwise.
the adjustment screw clockwise.
If the arm drifts downward,
If the arm drifts downward, turn
turn the adjustment screw counter-
the adjustment screw counter-
clockwise.
clockwise.
Depending on the weight of your
Depending on the weight of
monitor, you may have to make
your monitor, you may have
15-20 turns.
to make 15-20 turns.
In some instances, further
In some instances, further
counterbalance adjustments
counterbalance adjustments
are needed to allow the arm’s
are needed to allow the arm’s
instant height adjustment
instant height adjustment function
function to work properly.
to work properly.
If your arm is not staying in
If your arm is not staying in
position after performing step 1,
position after performing
follow these steps:
step 1, follow these steps:
(1)
Ergonomic solutions for office and light industrial work environments
©2016 Ergomart. All rights reserved.
(2)
3/32" Allen Wrench
With arm in ra
With arm in raised position,
tighten set screw (A).
tighten set screw (1).
With arm in horizontal position,
With arm in horizontal position,
tighten set screw (B).
tighten set screw (2).
Do not over tighten screws.
Do not over tighten screws.
ised position,
PAGE 2 OF 3
Loading...