ERGOMART Corner Shaper and Keyboard Arm Installation Instructions Manual
Corner Shaper and Keyboard Arm
Installation Instructions
™
www.ergomart.com
|
888 420 3200
r
1
C.
C.
C.
Fully tighten after step 2
Pre-assemble top and bottom portions of Corner Shaper
using Barrel Nuts. (Tighten Barrel Nuts in Step 2)
3
If using the CornerShaper without a track
B.
B.
A.
B.
A.
A.
B.
A.
B.
2
1) Slide Corner Shaper into corner of work surface
2) Tighten Barrel Nuts (shown in step 1)
4
If using the CornerShaper with a track
B.
A.
Bumper
Attach Corner Shaper to the bottom of work surface
using screws A and B in their designated holes.
5
Slide Keyboard Arm into Track
If using the CornerShaper with a track
Ergonomic solutions for office and light industrial work environments
©2014 Ergomart. All rights reserved.
Attach Corner Shaper and track to the bottom of work
surface using screws B. (Bumper purchased with track)
6
Install Stop
If using the CornerShaper with a track
B.
B.
B.
B.
Screw Diagrams
SCREW DIAGRAM WHEN NOT USING TRACK
A
A
B
THIS IS THE DIAGRAM FOR STEP 3
SCREWS TO USE FOR INSTALLING TRACK STOP
B
THIS IS THE DIAGRAM FOR STEP 6
B
B
B
B
A
A
B
A
B
SCREW DIAGRAM WHEN USING TRACK
BUMPER
B
A/B
A/B
A
B
B
THIS IS THE DIAGRAM FOR STEP 4
(”A/B” DESIGNATES THAT EITHER SCREW CAN BE USED)
A/B
A/B
A
B
B
A
Parts List
www.ergomart.com | 888 420 3200
ITEM DESCRIPTION/ PART NO. QUANTITY
Hardware Included
A 10-32 x 3/8” Screws 10
B 10-11 x 5/8” Screws 5
C Barrel Nuts 2
Tools Needed
Phillips Head Screwdriver
Slotted Screwdriver
1/8” Drill Bit (used for making pilot holes for Screw A)
Ergonomic solutions for office and light industrial work environments
©2014 Ergomart. All rights reserved.
Loading...