Ercol Rimini 3280, Rimini 3281, Teramo 2681, Teramo 2680, Salina 3890 Instruction Manual

ercol

Rimini bed

3280/1 double/kingsize beds

Thank you for purchasing this Rimini bed. Please read the instructions carefully before use to ensure safe
and satisfactory operation of this product.

This item is HEAVY

Pre-assembly preparation

Please ensure instructions are read in full before attempting to assemble this product

Please check the pack contents before attempting to assemble this product. A full checklist of components

is given in this leaflet. If any components are missing, please contact the retailer from whom you bought

this product.

This product is HEAVY, it should b
WHEN LIFTING to avoid personal injury and (or) damage to the product.

This product takes approximately 30 MIN UTES to assemble with 2 PEOPLE.

The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROM YOUNG

CHILDREN.

Necessary Tools

e assembled as near as possible to the point of use. TAKE CARE

Fittings and parts check list

A

B

C

D

E

F

G

Headboard x 1

Footboard x 1

Side rails x 2

Centre rail x 1

Slats double bed x 32
Slats king size x 34

Ends for slats double x 64

Ends for slats king size x 68

Threads x 8

H

Half moon washer

J

Spanner x 1

K

Central brackets x 2

L

Washers x 2

M

Nuts and bolts x 2 each

N

12mm Screws x 12

x 8

,

Step by step assembly instructions

1. Push the threads G into the headboard and the footboard as shown below.
Tighten the threads by hand ensuring that there is approximately half of the threads still showing.

2. Making sure the holes in the side rails,C, are facing upwards, AND you have the Left and Right rails, (see

page 2) on the corret sides, locate these side rails onto the protruding thread
board. As you do this, slide a half moon washer onto the thread when it comes through into the circular
hole in the side of the rail, then screw on one of the 8 nuts
corners. then

TIGHTEN FIRMLY WHEN ALL FOUR CORNERS ARE SECURED.

FINGER TIGHT ONLY. Repeat with the other 3

s on the headboard and foot

3. Using the 12 x 20mm screws, attach the two brackets into the headboard and the footboard using the

pre-drilled holes, tighten with a phillips screwdriver.

4. Making sure the holes in the centre rail are facing upwards, put the centre rail into the two brackets.

Secure it in place using the 2 x 40mm bolts, and the 2 washers and nuts.

5. Push a plastic cap onto each end of a slat and with the peg facing downwards push the slat into the pre

drilled holes as shown below. Repeat for all the slats.

PLEASE K EEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX www.ercol.com