ERALED Optoelectronics P16 User Manual

Specification of the control system

一、Components description

1、The sending card

① DVI input ,connected to the DVI output of the graphics card.
② Serial por,connected to the serial port interface of the

computer(RS232).

③ DIP interface,DC 5V power input.
④ 1U cable output,At output port 1.
⑤ 1D cable output,At output port 2.
⑥ Indicating lights of the power,the red light on for power

up.

⑦ Signal light,the green light on after the signal being

inputed.

⑧ DIP interface,DC 5V power input.
⑨ DIP interface,DC 5V power input.

2、The receiver card

① B-signal output or input.
② A-signal output of input.
③ DC 5V input.
④ Automatic inspection,the inspection button when there’s no

signal.

⑤ Signal lights,the green light flashing after signal input.
⑥ The indicating lights of power,the red light on for DC 5v

power up.

⑦ HUB interface,connect the screen to the conversion card with

the same signal.

⑧ HUB interface,connect the screen to the conversion card with

the same signal.

3、The graphics card

① DVI output,signal transmitted to the sending card 801.

② VGA output,signal transmitted to the display.

1、The Front Exploded View

256mm

Point Spacing16mm

Display Surface Of

The Cell Board

Veil

128mm

LED Lamp

2、The Back Exploded View

PCB Bottom Rind

Screw Hole

LED Drive IC

16P Signal Input
Row Needle

16P Signal

Output Connected

Row Needle

1、The Front Exploded View

1024mm

Moudle

Cabinet

Positioning

2、The Back Exploded View

Signal in

Handle

Signal out

door

lock

Power in

Power out

3、The Back Door Open Exploded View

Receiver card

Power

Power line Signal line screw

Connecting every cabinet and the order is as follows:

Screen fixing frame

After fixing one cabinet

Lock for connecting
with each cabinet

Handle