Equipex CS4E Parts List

OPERATION MANUAL
FOR
SODIR
HOT DOG MACHINE
MODEL CS4E
765 Westminster street • Providence. Rhode Island 02903 • U.S.A.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the following:
1. Read all the instructions.
2. Do not touch hot surfaces. Use handles or knobs.
3. To avoid electrical shock, do not immerse the power cord, plug, or connection box in water or other liquid.
4. Close supervision is necessary when any appliance is in use or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions, or has been damaged in any manner. Bring appliance to the nearest authorized service facility for evaluation, repair or adjustment.
7. The use of accessory attachments not recommended by the appliance manufacturer may cause injury.
8. Do not use outdoors.
9. Do not allow cord to hang over edge of table or counter, or to touch hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. Extreme caution must be used when moving an appliance containing hot oil.
12. Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any control to “OFF", then remove plug from the wall outlet.
13. Do not use appliance for other than its intended use.
14. SAVE THESE INSTRUCTIONS
INTRODUCTION
The SODIR Hot Dog machines are designed to offer European-style hot dog snack preparation. The unit features a hot dog steamer consisting of a water vat, Pyrex heat-resistant glass container with a cover and a two-compartment wire basket, and four heated spikes mounted on a stainless steel base. The sheathed heating element housed in the base is thermostatically controlled up to 300 F. The regulating thermostat has an integrated ON/OFF feature, as well as a hold ("continuous heat") function. The hot dog machine is furnished with a red power indicator light that add convenience for operator.
SPECIFICA TIONS
Model Electrical Plug Configuration
CS4E 120V, 1PH, 0.65KW, 6A NEMA-5-15P
INSTALLATION
The SODIR Hot Dog Machine needs to be connected to a grounded outlet of proper voltage (120V, 1PH). DO NOT place the unit in a damp area.
OPERATION
After the unit is completely assembled, remove the PYREX glass container and fill the water vat with clean water up to the maximum level (approximately 2" of water).
CAUTION: Always operate the Hot Dog machine with water in the vat
Return the glass container to its position on top of the water vat, insert the holding wire basket and place hot dogs in to the ba sket. Two-compartment holding basket allows to separate already steamed hot dogs from uncooked ones. Cover the glass container with the metal lid provided. To preheat the machine, set the regulating thermostat at full power. Allow 10-15 minutes to complete preheating. The red indicator light will go out when the temperature is reached.
Select the desired temperature by turning the thermostat knob accordingly. For continuous heating, turn the knob to the "C" position as marked on the thermostat dial. It
takes approximately 12-15 minutes to steam hot dogs. To create the space for the hot dog and heat the inside of the torpedo roll; slide the roll down the heated spike almost to the end, without piercing it. It takes 2-4 minutes to heat the roll from inside . Upon finishing, put condiments inside the roll and then slide a steamed hot dog or sausage into it.
To switch the unit off, turn the thermostat knob clockwise to the OFF position.
CLEANING
WARNING: Disconnect (unplug) electrical power supply before cleaning
CAUTION: Do not spray the hot Pyrex glass container with any liquid
Cleaning is very important in maintaining a safe and well working machine. Allow the Hot Dog machine to cool before cleaning. The water vat, the Pyrex glass container, the cover and the holding basket are dishwasher safe. Remove them from the unit and wash in the dishwasher or in a pot sink. Use a cloth or a sponge dampened slightly with a soap and water mixture to clean the exterior surfaces of the base and the spikes. Use a clean lint-free cloth to remove excess water or soap.
DO NOT use an abrasive sponge on exterior surfaces DO NOT immerse the unit into water or wash it under running water DO NOT spray the exterior housing with any liquid DO NOT allow water to drip into the motor housing or onto electrical components
Inspect all parts on a regular basis to ensure that all parts are in good working order. If a part is damaged, have the unit repaired by an authorized service agency prior to returning the unit to operation. If you have trouble locating a service agency in your area, call EQUiPEX, LTD. at 1­800-649-7885 and ask for customer service.
SODIR EURO HOT DOG MACHINE
MODELS CS4E
EQUIPEX, LTD. 765 Westminster Street, Providence, RI 02903
tel: (401)273-3300 fax: (401)273-3328
SODIR Model CS4E Hot Dog Machine (120V/60/1 Phase)
Drawing # Part Number Quantity Description Old Part Number
1 A17001 1 Lid Handle P-S117001 2 F05038 1 Lid P-S633208 3 F04012 1 Hot Dog Basket P-S604012 4 F05009 1 Pyrex Glass P-S605009 5 F05022 1 Water Vat P-S605022 6 A10001 1 Strain Relief Connector P-S110001 7 OEM0011 1 Power Cord, 120V (no plug) P-S303006 8 A14042HD 1 Knob P-S114029
9 A08002 1 Red Pilot Light, 120V P-S108005 10 A04006 1 Regulating Thermostat P-S104001 11 A13001 4 Foot P-S113001 12 D02001CS4 1 Heating Element, 120V P-S402001 13 A15001 2 Handle P-S115001 14 F05010 4 Bread Spike P-S605010 15 460031108 1 Heating Element Casing n/a
14-Sep-00 SPHODO-4E-03
Toll free: 1-800-649-7885
Loading...