Equip USB 2.0 FOR NEC CHIPSET User Manual

Manual

www.equip-info.net

USB 2.0 FOR NEC CHIPSET

english

Manual_Page 2

www.equip-info.net

Index

1.0 USB Port Features

____________________________________________________________________________

3

2.0 System Requirement

________________________________________________________________________

4

3.0 Driver Limitations

____________________________________________________________________________

4

4.0 Driver Installation (Windows XP)

____________________________________________________

4

5.0 Driver Installation (Windows 2000)

____________________________________________________

7

6.0 Driver Installation (Windows ME)

____________________________________________________

10

7.0 Driver Installation (Windows 98/98SE)

____________________________________________

12

Manual_Page 3

www.equip-info.net

Introduction

Add a USB device to your PC

Instantly add USB peripherals to your PC or Notebook. Never open your computer case
again after you have your USB Port (PCI) card installed and say good-bye to confusing
cables. The USB Port (Universal Serial Bus) allows you to instantly connect USB devices
to your computer. The USB Port will allow you to attach 2/3/4/5 USB devices instantly.
You never have to worry about running out of slots in your computer or those confusing
IRQ’s again. You can also “Hot Swap” your USB devices. What does this mean? You never
have to power down your PC to install hardware again. Gamers can switch joysticks on
the fly. Welcome to the USB Revolution.

1.0 USB Port Features

The PCI is a true 32-bit PCI-Bus USB card. The CardBus is the trade name for an advanced
PC Card (also known as PCMCIA card) specification. It fits in a slot like a conventional PC
card and 32-bit path is used for data transfer. It supports the following I/O features:

• 2/3/4/5 USB ports (root hub and two/three/four down stream function ports)

• Auto detect speeds and connections of devices

• Support High Speed Data Transfer Rates of up to 480 Mbps

• Integrated physical layer transceivers

• Normal and low power operating modes

• Fully Plug and Play compatible

• OHCI (Open Host Controller Interface) specification V1.0 register compatible

• USB specification V.1.0 compatible

• AC-DC Adapter: 120V INPUT 60Hz 10.1w, OUTPUT 5V DC 1A

230V INPUT 50Hz 100mA, OUTPUT 5V DC 1A

If you use PCMCIA USB card, you don’t need to use AC-DC adapter that you connect to
USB devices. Only in one case that system request more power and please use our AC-DC
adapter.

Manual_Page 4

www.equip-info.net

2.0 System Requirements

This setup program will install the driver for NEC USB 2.0 Host Controller. Before you start
to run the setup program, please make sure your computer is an IBM PC-compatible
system.

This driver can be used either the following operating systems:

• Windows98

• Windows98 Second Edition.

• Windows Millennium.

• Windows 2000.

• Windows XP.

3.0 Driver Limitations

Current limitations of the driver are: Composite devices and Hi-Speed Isochronous
Transfers are currently not supported.

4. Driver Installation (Windows XP)

1. Please make sure this PCI/PCMCIA card has been installed on your system correctly.

When starting Windows XP, it will display the following screen, please select “Install
from a list or specific location [Advanced]”.

Manual_Page 5

www.equip-info.net

2. Insert the “Driver CD” into the CD-ROM and select the “Include this location in the
search”. Please use the Browse to change the path to “your cdrom driver:\USB\Item\98 me
2k xp”.

3. When display Hardware Installation screen, Press “Continue Anyway”.