Page 1
Crimping Tool Professional
Crimping 8P8C/RJ45 - 6P6C/RJ12 - 6P4C/RJ11 - 4P4C/4P2C
1a 1b 2
345
678
Instructions
To open the handles squeeze handles until it stops.
1a Insert the 4P or 6P cable from the two-bladed side
of the stripper until it touches the stop guide
(stripping length 6mm).
1b Insert the 8P cable between the two stripper blades
and let it extend a little over the lower cut blade.
2 Squeeze handles until stop, keep the cable perpendicular
and then pull from the tool.
3 Insert round cables into the round stripping hole,
squeeze handles until stop, turn the tool in counter
clockwise direction and the cable in clockwise direction
simultaneously, pull from the tool.
4 Insert the stripped cable into the plug and make sure
that the left wire at one end matches the right wire
at the other end.
5 Place the modular plug with cable into the tool's holder.
Be sure the stripped wire is between the tab and the gold
contacts. Squeeze the handles until stop.
6 Remove the crimped plug from the tool.
7 To release the ratchet turn the screw on the ratchet
in counterclockwise direction.
Package Contents
Q 1x Crimping Tool Professional
Q 1x Screw Driver
8 To crimp DEC plugs remove the screw on the left side
of the 6P holder, insert the DEC plug with cable into
the 6P holder and squeeze handles until stop.
Loading...