Equilume Stable Light Product Manual

performance lighting
Stable Light Product Manual
1
2
Contents
1. Introduction 4
2. Product Information 4
2.1 Specications 4
2.1.1 Stable Light 5
2.1.2 Controller 5
3. Installation instructions for electricians 6
3.1 Warnings 6
3.2 Installation Instructions for Stable Light and Controller 6
4. Safety Information 8
5. Getting Started: Instructions for Users 8
5.1 How to navigate through the Controller menus 8
6. How to Set-Up, Pair and Program Lights 8
7. How to deactivate a light or change programs 12
8. How to turn on the white light for an individual Stable Light at night 12
10. How to activate the white light at night for all lights in an emergency 13
11. How to change PIN Number 13
12. How to change date and time 13
13. How to change Controller ID 13
14. How to change Location 14
15. Care and cleaning 14
16. Product warranty 14
17. Technical support 14
3
1. Introduction
The Equilume Stable Light provides the horse with biologically effective light in a system that replicates the benets of nature’s environmental lighting for the stabled horse. When installed and programmed according to this manual, the lights are designed to maximize health, performance and breeding efciency by naturally strengthening the horse’s circadian rhythms.
2. Product Information
2.1 Specications
Specications Controller Stable Light
Input power/current 55W 300mA
Output power/current 50W 1A
Protection Over voltage, load and
temperature
Mains Frequency 47-63 Hz 47-63 Hz
IP Rating IP65 IP65
Dimensions 140 x 110 x 60 mm (5.5 x
4.3 x 2.4 in)
Weight 0.7 kg (1.5 Ibs) 4.2 kg (9.3 Ibs)
RF Frequency – EU/UK 868 MHz 868 MHz
RF Frequency – AUS/NZ 915 Mhz 915 Mhz
RF Frequency – USA/CA 915 Mhz 915 Mhz
Range RF: 0 - 1 km (0 - 0.6 mi) RF: 0 - 1 km (0 - 0.6 mi)
Light coverage 4.5 x 4.5 x 3.5 m (15 x 15
Operational temperature range
Rated Life (24/7
-20º C to 50º C* (-4º F to 122º F)
> 50,000 hrs > 30,000 hrs
operation)
Limited Warranty (24/7
2 years 3 years
operation)
Compliance CE, WEEE, RoHS, EMC
and FCC
Over voltage and load
384 x 384 x 230 mm (15 x 15 x 9 in)
x 11.5 ft)
-40º C to 50º C (-40º F to 122º F)
*The screen on the Controller is rated to withstand temperatures from -20º C to +50º C (-4º F to 122º F). If environmental temperatures are expected to exceed this range then it is recommended that the Controller is further insulated.
4
2.1.1 Stable Light
The Stable Light is powered by a single-phase mains electrical cable at a voltage of 80-264 VAC and is provided with 30 cm (11.8 in) mains ex cable with an IP65 rated in-line connector so that the installer can connect with ease to the mains electrical supply. The Stable Light measures ambient light and adjusts its output accordingly to create the desired light intensity within the beam range. The Stable Light is protected by a protective guard (blue cover) to protect against ingress of dust and debris. This provides full upright coverage
and ventilation.
The protective guard has openings on either side for the installation of a mounting bracket (U shape) that is supplied separately when required. This bracket can be connected to the internal Stable Light chassis. This allows the
Stable Light to operate at an angle if needed.
The Stable Light is resistant to corrosion and degradation that could be caused by nitrates and other gases produced within the stable
environment.
2.1.2 Controller
The Controller is powered by a single-phase mains electrical cable at a voltage of 80-264 VAC and is provided with 30 cm (12 in) mains ex cable with an IP65 rated in-line connector for the installer to connect with ease to the mains electrical supply. The Controller comprises a 9 cm (3.5 in) anti-glare colour screen with a white backlight situated above a variety of buttons. The buttons are integral to the membrane with 5 main control options; up, down, right, left and select. There is also a red emergency override button (!) that when pressed, turns on the bright white light in all Stable Lights paired with that Controller.
2.1.3 Accessories
A 2 m (6.6 ft) black chain and 2 carabiner clips are provided, to enable the
hanging of the Stable Light vertically via the main loop on the top.
5
Loading...
+ 11 hidden pages