EPV Prime Vision ISF Series, Peregrine ISF Series User Manual
JA-022818 www.EPVscreens.com 1
Matte White Fixed Frame Projection Screen
Prime Vision ISF Series
User’s Guide
Thank you for choosing the Prime Vision ISF fixed frame projection screen! The Prime Vision ISF Series by
EPV Screens® leads the industry in quality fixed frame projection screens. Its design features a 2.4” wide
frame with velvet coating that frames its ISF Certified ChromaWhite screen material. The ChromaWhite is
specially formulated to provide diffusion uniformity with accurate color reproduction for a flat spectral
response in a controlled room environment.
Please read through this user guide before utilizing the screen. Correct usage and maintenance will ensure a
long product life.
Care & Use Instructions: Dust, dirt and scratches on the projection surface will affect the picture
quality, please take note of the points below to prevent that from occurring:
1. Do not touch the projection surface with your hands
2. Do not write or draw on the projection surface
3. Do not use fingers or sharp objects to point on the projection surface.
4. Use clean water when dampening the cleaning cloth and do not rub against the material.
5. Do not use chemical cleaning agents or alcohol to clean the screen material.
Note: Please make sure all parts are included in your package before assembling your Prime Vision ISF
fixed frame projection screen.
Hardware and Parts List
A. Frame Parts x 6 pcs
(4 top/bottom frame pcs + 2 side frame pcs)
H. M5x15 screw x 16 pcs
B. ChromaWhite Screen Material x 1 pc
I. Center Support Bar x 1 - 2 pcs
(depending on model/size)
C. Center joint x 2 pcs
J. Support joiner x 2 - 4 pcs (depending on model/size)
(Install into the support bar before shipment)
D. Elbow Joint x4 pcs
K. Fix Plates x 60 - 180 pcs
(depending on model/size)
E. Wall bracket x 4 pcs
L. Rubber mallet x 1 pc
F. Wood screw x 8 pcs
M. Screw driver x 1 pc
G. Hollow wall anchor x 8 pcs
JA-022818 www.EPVscreens.com 2
FRAME ASSEMBLY
1. Insert the center joint (c) connector to the horizontal frame piece with bevel connection and flat head, and
then fasten it with two M5x15 screws (h).
2. Insert the other horizontal frame piece to the center joint connector and then fasten it with two M5x15
screws.
Note: a. 2 long frames should be assembled for a screen.
b. Do not tighten the screws completely until all frame pieces have been assembled correctly.
3. Insert both elbow joint connectors into the long horizontal frame and then fasten it with two M5x15
screws (see Fig.1). Then insert the short frames and fasten them with screws (Fig.1.2).
Push
Push
Joint
Long frame
( fig.1)
Flat head
bevel connection
Bevel connection
Flat head
×2
½ Long Frame
½ Long Frame
Push
Horizontal Long Frame
M5x15 Screw
M5x15 screws
M5x15 screws
JA-022818 www.EPVscreens.com 3
Push
Push
( fig.2)
Insert the exposed ends of the joint connectors
into the short (vertical) frame and align the four
corners so that they meet at perfect right angles
4. Join all four frame parts together following the steps shown below. (Fig.2)
Note: When assembled, please push simultaneously the two ends of the long frames.
Push
Push
Short frame
Short frame
M5x15 screws
Screw
M5×15Screws
Screw
(Fig.1.1)
(Fig.1.2)
Loading...