E Power RUMBLE User Manual

55mm

75mm

COMPONENTS INCLUDED:

1 x Rumble Bluetoth Speaker Stand
1 x User Manual
1 x Charging Cable
1 x Audio Cable

DESCRIPTIONS OF EACH KEY:

SM-3765 Rumble Bluetoth Speaker Stand

Instruction Manual

SM-3765

Page 1

①　　AUX
②　　ON/OFF
③　　Charging Indicator
④　　Charging Port

Short press: Volume down

⑤

Long press: Move to next music
Short press: Volume up

⑥

Long press: Move to previous music

BLUETOOTH SPEAKER OPERATION:

>>Turn on the speaker, Blue indicator light will flash rapidly
to detect nearby Bluetooth enabled devices.
>> Look for “Rumble” appear on the list of Bluetooth
devices from your device. Type Password “0000” or “1234”
if requested

⑦ Play/Pause
⑧ Status Indicator
⑨ Microphone

Page 3

④

①

③

②

⑤

⑥

⑦

⑨

⑧

Page 2

>>Once unit is successfully paired and connected. Blue
lights slowly.

CHARGING THE RUMBLE

When the device is charging, a Red LED light will turn on to indicate
it is charging. The light will turn off when it is fully charged.

CONNECTED WITH THE LINE-IN FUNCTION:

Connect the Line-in/AUX cable to your mobile device’s AUX port.
Connect the other end of the AUX cable to the line-in port on the
speaker. Your mobile device should immediately transfer to the
Rumble Bluetooth Speaker.

SAFTY INFORMATION:

Avoidsources of intense heat or flame.
Do not insert metal objects into item. (Shirt circuit risk)
Do not attempt to repair the device. Rather, contact a service
Professional.

Page 4

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.

NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 5 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause

Page 3

harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:

The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.

Page 4