EPH Elektronik GS 24 S - 360 User guide

Assembly instruction / User manual

Chopper controller for DC motors type GS 24 S - 360

Technical data under reserve technical changes

Please read these instruction before using and please keep safe for future.
You may download further technical advice under www.eph-elektronik.de.

Stand August 2018 Z385-MG

Seite 1 von 9

Table of contents

1. Safety Instructions and Safeguarding ................................................................ 3

1.1. Installation note.......................................................................................... 3

1.2. ESD-protection / Hazard note .................................................................... 3

3. Connecting ......................................................................................................... 5

3.1. Connecting diagram ................................................................................... 5

4. Option change of rotating direction – Type:393 ................................................. 6

4.1. Generell information / Operation ................................................................ 6

4.2. Terminal block layout x1: Type 393 ........................................................... 7

4.3. Connection for change of rotating direction option ..................................... 8

5. Declaration of Conformity ................................................................................... 9

Stand August 2018 Z385-MG

Seite 2 von 9

Attention during

Danger to burn

-

Danger to fire

-

1. Safety Instructions and Safeguarding

1.1. Installation note

An external mains adapter is required for the electrical supply of the controller
EPH 360. If this mains adapter is itself supplied with a voltage >75V AC or
>50V DC the following points have to be considered:
The unit should only be installed by qualified specialist personnel. Installation
and operation of the unit should comply with the local regulations for electrical
installations as well as health and safety regulations. The protection of people
and property must be warranted by applying the currently applicable safety
regulations (VDE, electrical safety regulations, IEC, etc.). High start-up
currents can occur at the moment of tuning on a controller device / mains
adapter due to charging process of the intermediate circuit. An effective
safeguard is therefore required on the mains input side (e.g. a C-Rated 16A
line circuit breaker). The use of RCD circuit breakers before control unit /
mains adapter is not recommended because of the leakage currents
generated by EMC interference suppressing devices. The regulator card /
mains adapter must not be operated without an effective connection to earth!
The connection to earth must comply with local regulations.

1.2. ESD-protection / Hazard note

installation of the
electronic board!

It must be warranted on
your part that there is
sufficient ESD-protection.

Stand August 2018 Z385-MG

Parts of this controller
card can be reach a
temperature up to
80°C.
Increased risk at
controller cards
without protective
cover.

Beware!

Beware!

Unprofessional
handling and
installation can
cause a fire.

Danger to life-Beware!

Parts of this controller
card are under
intermediate circuit
voltage and remain
energised >50VAC
respectively 75VDC after
turning main power off.
Coming into contact with
the terminals, lines and
unit parts can cause
serious injuries or result in
death!

Seite 3 von 9