eOUTIL AE310 Installation guide

AE310 Battery Tester/Analyser

Test functions

- Voltage

- Resistance

- Battery Condition Percentage

- Cold Cranking Amps(CCA)
Technical Specications:

- Voltage accuracy:+/- 0.03V

- Resistance accuracy:+/- 0.3mΩ

- Low battery indication: 12.4V± 0.1V

- CCA range: 0-1995

- AH range: 0-199.5

- Uses 12V battery for power and does
not require its awn battery to operate

- Large easy-to-read backlit display

- Working temperature: 0°C-50°C

Operation procedure:
First, for battery testing, ensure the clamps are
clean. Place the clean analyser clamps around
the battery posts during test. Red clamp (positive)
terminal and black clamp (negative) terminal
should be attached to corresponding battery
terminal. For higher accuracy, both sides of
each battery clamp need to have a solid
connection with the terminal posts. A partial
connection may result in the displaying on
the left of the screen or cause the unit not to
turn on at all. To correct, ensure the clamps are
properly fastened.

of the display. The value on the left of
the four-digit display blinks indicating
the digit is changeable by pressing the
 (increasing) or  (decreasing) function
buttons. Press the  (increasing) or 
(decreasing) function button until the
correct digit shows and move to the
next place value for input by pressing
"SEL" button. The button on the far
right of the four-digit display changes
from 5-0 when increased or decreased,
the other digits change one number at a
time. According to the dierent modes

(CCA or Volts), rst row is the entered
CCA or the voltage value for the battery.
Second raw is the actual CCA value or
mO resistance of the battery.
Note: If AH symbol is blinking, display
entered CCAs were estimated from
entered AH value.
After input values are entered, press the
"OK" button. The analyser will start
testing mode. A tone will sound for one
second when the testing mode is
complete. To re-test, press the button.
Checking results: The index below the

To turn o the analyser, remove clamps
from terminals.

Battery Facts & Info.

CCA(Cold Cranking Amps): One of the
most important ways to rate Battery
Capability is with CCA(Cold Cranking
Amps). Each battery, as it comes from
the manufacturer, has a CCA rating
associated with it. As the battery gets
older its CCA will go down until
eventually the vehicle will not start and

bar graph on the display screen shows
the capacity of the battery which has a
indication range from 0-100%

- If the bar graph displays less than 40%,
it indicates the battery is broken or too
old and should be replaced.

- Graph displays between 40% to 60%,
the battery is old, replacement
should be considered.

- Graph display between 60% to 80%,
the battery is workable.

- Graph displays between 80% to
100%, the battery is in good
condition.

the battery needs replacing. The main
reason for the CCA decrease is Battery
Sulfation.