Envision Peripherals EN-780e-31MY02, EN-780e 1, EN-780e 17, 31MY02 User Manual

EN-780e

17 inch Flat CRT Color Monitor

User’s Manual

by Envision Peripherals, Inc. www.ENVISIONmonitor.com

EN-780e_31MY02

Before operating your monitor, please read this manual thoroughly.

31MY02

For Your Safety

EN-780e

FCC Statement

This equipment h as been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio f re quenc y energy, and if not installed and used in ac c ordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can b e determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or reloca te the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the rec eiver i s connected.

4. Consult the dealer or an experienced radio/TV technician for help.

Notice

1. The changes or modifications not expressly approved by the party res pons ible for compliance could vo id the user's authority to operate the equip ment.

2. Shielded interface cables and AC power cord, if any, must be used in order to comply with the emissionlimits.

3. The manufacturer is not responsible for any radio or TVinterference caused by unauthorized modification to this equipment. It is the responsibility of the user to correct such interference.

As an ENERGY STAR Peripherals, Inc. has determ ined that this product

meets the ENERGY STAR efficiency.

Partner, Envision

guidelines for energy

Warning

To p re ve nt fire or shock hazard , do not expose the monitor to rain or moist ure. Dangerously high voltage is present inside the monitor. Do not open the cabinet. Refer servicing to qualified personnel only.

EN-780e

31MY02

For Your Safety

EN-780e

Precautions

• Do not use the m onit or near water, e. g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basemen t.

• Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serio us damage to the appliance. Use only a cart or stand recommended by the manufacturer or sold with the monitor. If yo u mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the kit instructions.

• Slots and openings in th e back and bottom of the cabinet are provided f or v entilation. To ensure reliable operation of the monitor and to protect it from overheating, be sure these openings are not block ed or covered. Do no t place the monitor on a bed, sofa, rug, or similar surface. Do not place the monitor near or ov er a radiator or heat register. Do not place the monitor in a bookcase or cabinet unless proper ventilation is provided.

• The monitor should be operated only with t he type of power source indicated on the label. If you are not sure of the type of power supplied to your home, consult your dealer or local power company.

• The monitor is equipped with a three-pronged grounded plug, a plug with a third (grounding) pin. As a saf ety feature, this plug will only fit into a grounded power outlet. If your outlet does not accommodate the three-wire plug, have an electrician install the correct outlet, or use an adapter to ground the appliance safely. Do not defeat the safety purpos e of the grounded plug.

• Unplug the unit during a lightning storm or w hen it will not be used for long periods of time. This will protect the monitor from damage due to power surges.

• Do not overload power strips and extension cords. Overloading can result in fire or electric shock.

• Never push any object into the slot on the monitor cabinet. It could short circuit parts causing a fire or electric shock. Never spill liquids on the monitor.

• Do not attempt t o serv ice the monitor yourself; opening or remo ving covers can expos e you to dangerous voltage and other hazards. Please refer all servicing to qualified service personnel.

• To ensure satisfactory operation, use the monitor only with UL-listed computers which have appropriately co nfigured receptacles marked between 100 - 240 V AC , Mi n. 3.5A.

EN-780e

• The wall socket s hould be installed near the equipment and should be easily acce ssib le.

31MY02

For Your Safety

EN-780e

General Notes

• Do not install the monitor near heat sources such as radiators or air duc ts.

• Do not place monitor in direct sunlight or in areas with excessive dust, mechanical vibration or shock.

• Save the original shipping carton and packing materials in case you need to ship your monitor. Be sure to repackage your monitor as it was originally packed at the factory.

• Periodically clean your monitor with a soft cloth. Stubborn stains may be removed with a c loth lightly dampened with a mild detergent solution.

Never use strong solvents such as thinners, benzene, or abra sive cleaners, since these willdamage the cabinet. Always unplug the

monitor before cleaning it.

Using the Right Power Cord

ThesuppliedpowercordisaNEMA5-15style plug. It is UL-listed and CSA labeled for 125 volts AC.

If the monitor will be connected to your c omputer’s power outlet, use a minimum No. 18 AWG, type SJT or SVT three conductors cord with one end terminating with a male grounded plug, rated 10A , 250V, CEE-22. The other end must terminate with a molded-on type connector body, rated 10A, 250V, having standard CEE -22 f emale configuration.

General Features:

• 17" (43.2 cm) Color Monitor

• Crisp, Clear Display for Windows

• Supports Resolutions up t o 1600 X 1200 pixels @75Hz

• EPA ENERGY STAR

Package Contents

The box that your monitor was shipped in should have included the following i tems :

1. EN-780 e Color Monitor

2. Power Cord

3. Quick Start Guide

4. Bookl et (containing Warranty and Safety information)

EN-780e

31MY02

Before You Operate the Monitor

Installing & Removing the Base

EN-780e

31MY02

Before You Operate the Monitor

Connecting the Wires Using the Power Cord Supplied

EN-780e

1. Connect the bu ilt-in vid eo cable into the 15-pin connector on the back of your computer and tighten the two screws.

2. Connect the po wer cord into your monitor's power input socket.

3. Plug the other end of the power cord i nto a grounded AC outlet or UL-approved power strip.

EN-780e

Caution:Make surethepowercordis thecorrect type that is required in your area. This monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V A C voltage areas (no user adjustment is required).

If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied).

31MY02

+ 11 hidden pages