Envision EN-775e User Manual

EN-775e

EN-775e

17 inch Flat CRT Color Monitor

User’s
Manual

EN-775e 053102

by Envision Peripherals, Inc.
www.ENVISIONmonitor.com.com

Before operating your monitor, please read th is
manual thoroughly.

1

31MY02

For Your Safety

EN-775e

FCC Statement

This equipment has been test ed and found t o
comply with the limits for a Class B digital device,
pursuant t o Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy, and if not
installed and used in accordanc e with the
instructions, may cause harmful interference to
radio c ommunications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be de termined by turning the
equipment off an d on, the user is enc ouraged to try
to correct the interference by one or more of the
following measures:

1. Reorient or reloca te the receiving antenna.

2. Increase the separation between the equipment
and receiver.

3. Connect the e quipment into an outlet on a circuit
different from that to which the receiver is
connected.

4. Consult the dealer or an experienced radio/TV
technician for help.

Notice

1. The changes or modi fications not expressly
approved by the party responsi ble for
compliance could void the us er's authority to
operate the equipment.

2. Shielded interface cabl es and AC power c ord, if
any, must be used in order to comply with the
emissionlimits.

3. The manufacturer is not responsible for any
radio or TV interference caused by unauthorized
modification to this equipment. It is the
responsibility of the user to correct such
interference.

As an ENERGY STAR
Peripherals, Inc. has determined t hat this product

meets the ENERGY STAR
efficiency.

®

Partner, Envision

®

guidelines for energy

Warning

To prevent fire or shock hazard, do not expose the
monitor to rain or m oist ure. Dangerously high
voltage is present inside the monitor. Do not open
the cabinet. Ref er servicing to qualified personnel
only.

EN-775e

2

31MY02

For Your Safety

EN-775e

Precautions

• Do not use the monitor near water, e.g. near a
bathtub, washbowl, kitchen sink, l aundry tub,
swimming pool or in a wet basement.

• Do not place the monitor on an unstable cart,
stand, or table. If the monitor falls, it can injure a
person and cause serious dam age to the
appliance. Use only a cart or stand
recommended by the manufacturer or sold with
the m onitor. If you mount the monitor on a wall
or shel f, use a mounting kit approved by the
manufacturer and follow the kit instructions.

• Slots and openings in the back and bottom of
the cabinet are provided for ventilation. To
ensure reliable operation of the monitor and to
protect it from overheating, be sure thes e
openings are not blocked or covered. Do not
place the monitor on a bed, sofa, rug, or similar
surface. Do not place the monitor near or over a
radiator or heat register. Do not place the
monitor in a bookcase or cabinet unless prope r
ventilation is provided.

• The monitor should be operated only with the
type of power source indicated on the label. If
you are not sure ofthe type of power supplied to
your home, co nsult your dealer or local power
company.

• The monitor is equipped with a three-pronged
grounded plug, a plug with a third (grounding)
pin. As a safety fe ature, this plug wi ll only fit into
a grounded power outlet. If your outlet does not
accommodate the t hree-wire plug, have an
electrician install the correct outlet, or use an
adapter to ground the appliance s afely. Do not
defeat the safety purpose of the grounded pl ug.

• Unplug the unit during a lightning storm or when
it will not be used for long periods of time.
This will protect the monitor from damage due to
power surges.

• Do not overload power strips and extension
cords. Overloading can result in fire or electric
shock.

• Never push any object into the slot on the
monitor cabinet. It could short circuit parts
causing a fire or electric shock. Never spill
liquids on the monitor.

• Do not attempt to service the monitor yourself;
opening or removing covers can expos e you to
dangerous voltage and other hazards. Please
refer all servicing to qualified service personnel.

• To ensure satisfactory operation, use the
monitor only with UL-listed c omputers which
have appropriately configured receptacles
marked between 100 - 240 V AC, Min. 3.5A.

EN-775e

• The wall socket should be installed near the
equipment and should be easily accessible.

3

31MY02

For Your Safety

EN-775e

General Notes

• Do not install the monitor near heat sources
such as radiators or air ducts.

• Do not place monitor in direc t sunlight or in
areas with excessive dust, mechanical vibration
or shock .

• Save t he original s hipping cart on and pac k ing
materials in c ase you need to ship your monitor.
Be sure to repackage your monitor as it was
originally packed at the factory.

• Periodically clean your monitor with a soft c loth.
Stubborn stains may be removed with a cloth
lightly dampened with a mild detergent solution.

Never use strong solvents such as thinners,
benzene, or abra sive cleaners, since these
will damage the cabinet. A lways unplug the

monitor before cleaning it.

Using the Right Power Cord

ThesuppliedpowercordisaNEMA5-15style
plug. It is UL-listed an d CSA labeled for
125 volts AC.

General Features:

• 17" (43.2 cm) Color Monitor

• Crisp, Clear Display for Windows

• Supports Resolutions up to 1 280 X 1024 pixels
@60Hz

• EPA ENERGY STAR

®

Package Contents

The box that your monitor was shipped in should
have included the following items:

1. EN-775e Co lor Monitor

2. Powe r Cord

3. Quick Start Guide

4. Booklet
(containing Warranty and Safety information)

If the monitor will be connected to your com puter’s
power outlet, use a minim um No. 18 AWG, type
SJT or SVT three conduc tors cord wi th one end
terminating with a male grounded plug, rated 10A,
250V, CEE-22. The other end must terminate with
a molded-on type connector body, rated 10A,
250V, having standard CEE-22 female
configuration.

EN-775e

4

31MY02

Before You Operate the Monitor

Installing & Removing the Base

EN-775e

EN-775e

5

31MY02