Envirovent ECO2 Air Twin, ECO2 Loftight Twin Installation Manual

You are about to install a product that is designed to outlast the life-cycle of the building.
Once installed the unit will operate continuously for 5 years and beyond without a major
service. Please therefore ensure that this product is treated with care and installed properly
i.e. for the life of the building. If the unit is mishandled you might break it! This invalidates
the warranty.

And remember, if you have any problems please call our dedicated Technical Team. We
are always pleased to help and in an emergency will come out to site quickly, completely
free of charge.

HOTLINE: [phone]

Due to our policy of continuous innovation and improvement EnviroVent reserves the right to alter

products specication and appearance without notice.

SHOULD YOU ENCOUNTER ANY PROBLEMS INSTALLING THIS UNIT CALL

0845 27 27 810

ECO2 Air Twin & ECO2 Loftight Twin

PRE-INSTALLATION CHECKLIST

Check that the loft has adequate cross ow

ventilation.

Check for any ued appliance which may draw

air from the loft, report to the client.

Check for any holes in the ceilings which may
allow leakage of air to the loft and repair as
appropriate.

Check that the water storage tank is covered.

1

2

3

4

Check that any ue which passes through the
loft is not damaged, seek advice if the ue is in

a poor state of repair.

IMPORTANT

Smoke Detectors

It is important that any open side of the plastic diuser is
not positioned within 1m of a smoke detector. If the diuser
cannot be repositioned, up to two sides of the diuser may
be closed o using the plastic blanking plate supplied so

that the open sides face a minimum 1.5m unobstructed
path away from the detector.

SAFETY AND RECOMMENDATIONS

All wiring must comply with Building Regulations
and the current I.E.E. Wiring Regulations (BS7671)
or the equivalent standards for your country. The

nal installation should be examined and tested by
a qualied electrician. This appliance is not intended

for use by any person with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the appliance. If the supply cord is damaged, it must
be replaced by the manufacturer, its service agent or

similarly qualied persons in order to avoid a hazard.

Check that all party walls are intact, seek
advice if the wall is missing or broken.

DO NOT REMOVE OR TAMPER

WITH ELECTRONIC CIRCUIT

BOARD

This is not a user function.

6

5

FIXING KIT

Contents

8 X FOAM PADS

4 X PLASTER BOARD PLUGS

4 X PENNY WASHERS

ROLL OF INSULATION TAPE

4 X WOOD SCREWS (10 X 1.5)

4 X WOOD SCREWS (10 X 3)

4 X WOOD SCREWS (8 X 1)

4 X WOOD SCREWS (8 X 1.5)

4 X CABLE TIES