Environmental Express Ogden 3200 User Manual
HotBlock
TM
Digestion System
Operation & Instruction Manual
800.343.5319 or 843.881.6560
n
Fax 843.881.3964
n
www.environmentalexpress.com
ENVIRONMENTAL EXPRESS
Copyright, Environmental Express, Inc., January 2011
Ogden 3200 Controller
Contents 1
Warranty Information 2
About Your HotBlock
- Part Numbers / Model Information / Specifications 3-5
Getting Started
- Installation Requirements / General Information 6
- Controller Settings (Pre Alarm) 7
- Controller Settings (Alarm) 8
- Adjusting the Temperature of Your HotBlock 9
Safety Information 10
Parts List 11
Circuitry Diagram 12-13
Troubleshooting Guide 14-16
EPA Approval Letter 17
Contents HotBlock Operation Guide
Environmental Express • 1Call 1.800.343.5319
Environmental Express HotBlock Manual, copyright Environmental Express, Revised September 2010.
HotBlock™LIMITED WARRANTY
T
he Environmental Express HotBlock is warranted against defects in materials and workmanship when used in
accordance with applicable instructions, for a period of one year from the date of shipment. This warranty
extends to parts, labor, and any approved transportation charges. This warranty applies only to damage or failure
caused by normal laboratory use. The warranty is limited to product repair. If Environmental Express is unable to
repair the HotBlock, the customer may, at his or her option, receive a replacement unit or a full refund. Operating the
HotBlock at temperatures higher than 150°C will void the warranty.
Environmental Express makes no other warranty, expressed or implied for this product with respect to merchantability,
fitness for a particular use or any other matter. Environmental Express is not liable for any consequential or compensatory
damages arising from use of, or in conjunction with this product. The maximum liability shall be the invoice price of this
product.
REPAIR POLICY—Under Warranty Repair:
If the HotBlock should fail to operate within the warranty period (one year from date of shipment) Environmental
Express will repair it and ship it back to the customer at our expense. The remainder of the warranty period will be
honored from the original ship date. Environmental Express will bear the cost of ground transportation both to and
from the customer’s location, and bear the cost of any parts, labor and cleanup required. However, if it is determined
that the damage to the HotBlock was caused by negligence or improper use, this warranty will not apply. The
warranty is also void if the system is used beyond its intended purpose or in the event of any unauthorized repair. In
such cases, reasonable and customary repair charges will apply. Repair charges will be quoted prior to work being
done.
REPAIR POLICY—Out of Warranty Repair:
If the HotBlock fails after the warranty period has lapsed, the repair procedure is as follows:
First, notify an Environmental Express Technical Service Representative of product’s failure and place an order for
repair. Whenever possible, our customer service technician will walk you through possible troubleshooting scenarios
which may enable you to repair your block on site. (See the troubleshooting section of this manual, pages 12-14).
If on site repair is not possible, the customer may return the non-working unit to Environmental Express using
appropriate shipping containers and insurance. Repair charges will be assessed and estimated prior to work being
done. Repair charges will include all freight costs as well as reasonable and customary charges for parts and labor.
Loaner HotBlocks MAY be available during the repair period. There are only a limited numberof these units.
A reasonable charge for “cleanup” will be charged if a loaner is issued. The customer will be responsible for all
shipping charges associated with a loaner unit.
ENVIRONMENTAL EXPRESS
490 Wando Park Blvd., Mt. Pleasant, SC 29464
800.343.5319 or 843.881.6560
n
www.environmentalexpress.com
Environmental Express • 2Call 1.800.343.5319
About Your HotBlock
TM
HotBlock Operation Guide
50mL Sample
36-well HotBlock
T
he SC100 with its 36-sample
capacity was the first model in the
HotBlock line and is used daily in
hundreds of laboratories around the
world. All electronics are self contained
and isolated in a separate compartment
below the block — no need for a
separate controller and clumsy cables.
For use with the SC100, we recommend
our disposable SC475 50mL digestion
vessels shown on page 15. This energy
efficient unit draws a maximum of 1080
watts and generates very little waste
heat. The SC100 is supplied with two
18-place polycarbonate racks (catalog #
SC200) to facilitate the loading and
unloading of samples.
Catalog # SC100,
36-Sample Capacity
50mL Sample
54-well HotBlock
T
he large capacity SC154 HotBlock
digests up to 54, 50mL samples in
a 15" X 21.5" footprint. This model
comes with three 18-place
polycarbonate racks (catalog # SC200),
allowing the operator to load or unload
18 samples at once. We recommend our
disposable SC475 digestion vessels
shown on page 15. The compact size of
the SC154 allows it to fit comfortably
inside our HEPA-filtered AirLite
TM
fume
enclosure. All HotBlock models are
equipped with the Safe-SampleTMfeature
to prevent runaway temperatures in
event of an electronic failure.
Catalog # SC154,
54-Sample Capacity
Specifications: SC100 SC154
Footprint: 15" x15" 15" x 21.5"
Crated Size: 23" x 23" x 17" 26" x 23" x 17"
Weight: 43 lb. 59 lb.
Shipping Weight: 58 lb. 78 lb.
Electrical: 120VAC*, 9 A 120VAC*, 14 A
Sample Capacity: 36 54
Nominal Sample Size: 50mL 50mL
Temperature Range: to 150°C to 150°C
Thermocouple: Type K Type K
All HotBlocks are also available in 240V.
Environmental Express • 3www.environmentalexpress.com
Environmental Express • 4
About Your HotBlock
TM
HotBlock Operation Guide
Call 1.800.343.5319
HotBlocks for
100mL Samples
F
or larger sample size, the SC150 and
SC151 HotBlocks are designed for
the digestion of 100mL samples.
Both blocks use disposable, graduated
125mL screw-cap polypropylene vessels.
Note that with the larger digestion
vessels faster sample reduction may
occur due to greater surface-to-volume
ratio.
The SC150 digests up to 25 samples
simultaneously and comes with two
polycarbonate racks, a 15-place rack
paired with a 10-place rack, to facilitate
loading and unloading of samples. The
SC151 accommodates up to 35 samples
and comes with a 15-place rack and two
10-place racks. Digestion cups and
accessories for 100mL blocks are shown
on page 17.
Catalog # SC150,
25-Sample Capacity
Catalog # SC151,
35-Sample Capacity
SC150 HotBlock is a 25-well Block for
100mL Samples.
The SC151 HotBlock is a 35-well
Block for 100mL Samples.
Specifications: SC150 SC151
Footprint: 15" x15" 15" x 21.5"
Crated Size: 23" x 23" x 17" 26" x 23" x 17"
Weight: 42 lb. 59 lb.
Shipping Weight: 54 lb. 65 lb.
Electrical: 120VAC, 9A 120VAC, 13A
Sample Capacity: 25 35
Nominal Sample Size: 100mL 100mL
Temperature Range: to 150°C to 150°C
Thermocouple: Type K Type K
All HotBlocks are also available in 220V.
Environmental Express • 5Call 1.800.343.5319
15mL Sample
96-well HotBlock
T
he SC196 HotBlock is for the
digestion of 15mL samples and has a
96 sample capacity. The
recommended digestion vessel, SC415,
has a total volume of 18mL and is
graduated in 5mL increments. Originally
designed for the mining industry, the
SC196 has proven effective for
applications requiring reduced sample
size, higher throughput and lower waste.
The external parts of this HotBlock are
made of corrosion-resistant materials
including Teflon®, Kydex®and graphite.
The heating source is a solid block of
Teflon-coated graphite. The SC196 has
the same safety and thermal controls as
other HotBlock models and has a
temperature range of ambient to 150°C.
The SC196 comes with three
polycarbonate racks that hold up to 32
samples each to facilitate loading and
unloading samples.
About Your HotBlock
TM
HotBlock Operation Guide
50mL Sample
12-well HotBlock
T
he 12-place HotBlock was designed
as a component for our SimpleDist
System but doubles as a compact
HotBlock for metals digestions. Digest
small batches of 50mL samples in a
compact footprint. Each block comes
with a 12-place polycarbonate transfer
rack, C6050.
Catalog # C6002,
12-Sample Capacity
C6002 Specifications—
Footprint: 8.55" x 18.5"
Crated Size: 22" x 19" x 13"
Weight: 30 lb.
Shipping Weight: 35 lb.
Electrical: 120VAC, 13A
Sample Capacity: 12
Nominal Sample Size: 50mL
Temperature Range: to 150°C
Thermocouple: Type K
All HotBlocks are also available in 220V.
SC196 Specifications:
Footprint: 15" x 21.5"
Crated Size: 26" x 23" x 17"
Weight: 59 lb.
Shipping Weight: 80 lb.
Electrical: 120VAC*, 14 A
Sample Capacity: 96
Nominal Sample Size: 15mL
Temperature Range: to 150°C
Thermocouple: Type K
All HotBlocks are also available in 240V.
Catalog # SC196
96-Sample Capacity
Loading...