Page 1
Triton Datasheet
Part No.: 51321
For latest version visit:
www.enttec.com
October 18 mfile ID: 4815382 Page|1
Pixel Triton
Features
• Web configurable
• Firmware updateable
• Supports the following DMX over Ethernet
protocols:
o Art-Net
o Streaming ACN (sACN)
• Configurable Static or Dynamic (DHCP) IP
(DHCP by default).
• Netmask and gateway updateable
• Up to 8 ethernet universes support
(maximum of 4 universes per output port)
• Configurable pixel ordering.
• Monitors and maintains device temperature
• Monitors and displays the power consumed
by each output
• Detects and indicates when the power
consumed by an output is on or above the
recommended value
• Monitors and displays the network traffic
for the DMX over ethernet protocol enabled
• Easily extendable network – daisy chain
ethernet connection
• Web faders for instant testing of setup
Safety Information
• This unit is intended for indoor use only.
• Do not expose this device to rain or
moisture, doing this will void the warranty.
• Make all the connections before you plug in
the mains power
• Do not remove the cover, there are no user
serviceable components inside.
Page 2
Triton Datasheet
Part No.: 51321
For latest version visit:
www.enttec.com
October 18 mfile ID: 4815382 Page|2
• Never plug this unit in to a dimmer pack
• Ensure proper earth connections
• Always be sure to mount this unit in an area
that will allow proper ventilation. Allow
about 6 inches (20 cm) between this device
and a wall.
• Power-supply cords should be routed so
that they are not likely to be walked on or
pinched by items placed upon or against
them, pay particular attention to the point
they enter and exit the unit.
Physical Dimensions
Ordering Information
Part Number
Description
75020-12
Pixel Triton (12VDC)
75020-24
Pixel Triton (24VDC)
Specifications
Item
Product Name
75020-12
75020-24
Input Voltage
90 – 264V AC
Input Frequency
47 - 63 Hz
Maximum Total
Output Power
260 W
300 W
Maximum
/output
Power
130W
150W
Current
10.83A
6.25A
Supported Protocols
Artnet 1/2/3, sACN
Output Protocols
WS2811, WS2812, WS2812B,
WS2813, SK6812, TM1804,
TM1812, TM1814, UCS2903,
UCS2904, APA-104, 9PDOT (8 –
16bit)
Maximum Pixel
count/output (RGBW)
512 RGBW pixels
Maximum Pixel
count/output (RGB)
680 RGB pixels
Maximum DMX
footprint/output
2048 channels
Operating
Temperature
-10 oC – 35 oC
Relative Humidity
20% - 90% (Non-condensing)
Connectors
2X RJ45 etherCON
1 X IEC connector
2X 3-Pin Female XLR
IP Rating
IP20
Cooling Method
Smart fan
Weight
(in kg)
Device
2.02
Boxed
Device
2.35
Dimensions
(in mm)
Device
335(L) x 129(W) x 43(H)
Boxed
Device
400(L) x 215(W) x 115 (H)
Page 3
Triton Datasheet
Part No.: 51321
For latest version visit:
www.enttec.com
October 18 mfile ID: 4815382 Page|3
Wiring Diagrams
• Always check that the voltage and output of Pixel Triton matches that of the tape/dots, before connecting.
• Network delay: 96 micro seconds per unit, for a standard 600 bytes Art-Net packet (when connected in network
daisy chain)
• Only one ethernet source must be used to drive the device at any single time.
• Ensure distance between Triton data output and tape/dots data input is no more than 50cm
• Through connection can be made with any of the three models Pixel Port, Pixel Octo or Pixel Triton
Output 3-Pin Female XLR Pinout
Not to be used as DMX output
Pin 1
Ground
Pin 2
Data
Pin 3
12V Triton
+12 VDC
24V Triton
+24 VDC
Do not connect the Positive voltage of output 1 (VCC 1) to positive voltage of output 2 (VCC 2)
Due to continuous improvements and innovations of all ENTTEC products, specifications and features are subject to
change without notice.
Loading...