BrightEye 92-M will downconvert any type of HD signal and
provides both an SD SDI output and an analog composite
output that are suitable for broadcast or monitoring. A
special Mirror Output Mode can be enabled, causing the
output image to be ipped left to right for use with oncamera talent. The built-in Frame Synchronizer allows
you to feed asynchronous signals to the BrightEye 92-M.
An external reference input allows genlock to a house
reference.
All vertical interval data and closed captioning is faithfully
passed. Sixteen channels of embedded audio are
supported. If the incoming video has embedded audio, the
audio will be safely bypassed around the video processing
and lipsync will be preserved.
Audio monitoring is easy with BrightEye 92-M’s convenient
3.5 mm mini jack. Just select the audio channels you want
to monitor from the front panel and plug in a headset.
The HDMI connector on the rear of the unit provides a future
proof monitoring interface. Plug it into most LCD monitors
for condence monitoring of your feed.
Input selection, gain control, and test pattern controls are
provided through the front panel interface. Audio presence
LEDs indicate which channels are detected. Controls for
crop, letterbox and pillarbox are accessed from the front
panel or BrightEye Mac or PC software.
Downconversion for monitoring or broadcast
SD Digital and Analog Composite Video Outputs
Analog Audio Monitor Output
Mirror Output Mode for On-Camera Talent
Graticule and Safe Title Generator
HDMI Output for Monitoring
Frame Sync
12 and 16 bit processing
Passes Embedded Audio
138
www.ensembledesigns.com tel +1 530.478.1830
Specications
Composite
or Tri-Level
Ref In
Genlock
HD SDI
Video In
Audio
Demux
HDMI Out
Headphone
Jack
HDMI
Xmtr
Monitor
Amp
Provides embedded pass through of all 16 audio channels
DownconversionAudio Mux
SD SDI Out
SDI Driver
SDI
Receiver
Composite
Out
Encoder
BrightEye 92-M
Serial Digital Input
Number One
Signal Type 1.485 Gb/s HD Serial Digital
(SMPTE 274M, 292M or 296M)
Impedance 75 Ω
Return Loss >15dB
Max Cable Length 100 meters for 1.485 Gb/s
Automatic Input Cable Equalization
Reference Input
Number One
Type 1 V P-P Composite Video
PAL or NTSC
or Tri-Level Sync
Impedance 75 Ω
Return Loss >40 dB
Analog Video Output
Number One
Type Composite PAL or NTSC
Return Loss >40 dB
Output DC < 100 mV
Serial Digital Output
Number Two
Type SD Serial Digital
270 Mb/s SMPTE 259M-C
Processing 12 and 16 bit
Impedance 75 Ω
Return Loss >15 dB
Max Cable Length 300 meters
HD Standards Supported
1080i (SMPTE 274M -4,5,6) 50, 59.94 or 60 Hz
720p (SMPTE 296M -1,2,3) 50, 59.94 or 60 Hz
1080p (SMPTE 274M -9,10,11) 23.98, 24, 25 Hz
1080sF (RP211 -14,15,16) 23.98, 24, 25 Hz
Monitor Output
Number One
Connector HDMI
Type Follows SDI out
Audio Monitoring Output
Number One
(select from eight channels)
Connector 3.5 mm stereo mini jack
General Specications
Size 5.625” W x 1.7” H x 5.5” D
(143 mm x 40 mm x 140 mm)
including connectors
Power 12 volts, 10 watts
(100-230 VAC modular power
supply not included)
Temperature Range 0 to 40° C ambient
Relative Humidity 0 to 95%, non-condensing
www.ensembledesigns.com tel +1 530.478.1830
139
BrightEye 92-MA
HD Downconverter with Analog Audio
BrightEye 92-MA will downconvert any type of 1.5 Gb/s
HD signal and provide both an SD SDI output and an
analog composite output that are suitable for broadcast
or monitoring. Two channels of analog audio out are also
provided.
All vertical interval data and closed captioning is faithfully
passed. Sixteen channels of embedded audio are
supported. If the incoming video has embedded audio, the
audio will be safely bypassed around the video processing
and lipsync will be preserved.
The HDMI connector on the rear of the unit provides a future
proof monitoring interface. Plug it into most LCD monitors
for condence monitoring of your feed.
Conversion mode, video gain, and audio gain can be
adjusted from the front panel or BrightEye Mac or PC
software.
Downconversion for Monitoring or Broadcast
SD Digital and Analog Composite Video Outputs
Analog Audio Outputs
HDMI Output for Monitoring
Frame Sync
12 and 16 bit processing
Passes Embedded Audio
140
www.ensembledesigns.com tel +1 530.478.1830
Specications
2 Channels
Balanced Analog
Audio Output
HD to SD Downconversion
Ancilliary Processing
Embedded Audio
Serializer
+
Audio
Disembedder
Channel
Select
Audio
DAC
Deserializer
Analog
Composite
Encoder
HD SDI
Loop Out
SD SDI Out
Analog
Composite Out
• Scaling
• Aspect Ratio Conversion
• Color Space Conversion
HDMI Out
HDMI
Xmtr
HD SDI In
SDI
Reclock
BrightEye 92-MA
Serial Digital Input
Number One
Signal Type 1.485 Gb/s HD Serial Digital
(SMPTE 274M, 292M or 296M)
Impedance 75 Ω
Return Loss >15dB to 1.485 GHz
Max Cable Length 100 meters for 1.485 Gb/s
Automatic Input Cable Equalization
Number One
Type Composite PAL or NTSC
Return Loss >40 dB
Output DC < 100 mV
Serial Digital Output
Number One
Type SD Serial Digital
270 Mb/s SMPTE 259M-C
Processing 12 and 16 bit
Impedance 75 Ω
Return Loss >15dB to 1.485 GHz
Max Cable Length 300 meters
Monitor Output
Number One
Connector HDMI
Type Follows SDI out
Analog Audio Outputs
Number Two
Type Balanced, transformerless
Impedance 30 Ω
Maximum Output Level 24 dBu
Resolution 24 bit, 128 x oversampled
Reference Level -10 dBu or +4 dBu
Frequency Response ± 0.1 dB, 20 Hz to 20 KHz
Crosstalk <106 dB
Dynamic Range >106 dB
General Specications
Size 5.625” W x 0.8 ” H x 5.5” D
(143 mm x 20 mm x 140 mm)
including connectors
Power 12 volts, 12 watts
(100-230 VAC modular power
supply not included)
Temperature Range 0 to 40° C ambient
Relative Humidity 0 to 95%, non-condensing
www.ensembledesigns.com tel +1 530.478.1830
141
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.